User manual BOSS 606C
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BOSS 606C. We hope that this BOSS 606C user guide will be useful to you.
Manual abstract: user guide BOSS 606C
Detailed instructions for use are in the User's Guide.
[. . . ] The two supplied keys release tabs inside the unit's sleeve so you can remove it. Insert the keys as far as they will go (with the notches facing up) into the appropriate slots at the middle left and right sides of the unit. Then slide the sleeve off the back of the unit.
3
INSTALLATION
Sleeve L Key Outer Trim Ring Front Panel
Note: to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard.
Spring Washer Metal Strap Mounting Bolt Plain Washer Tapping Screw Hex Nut
R Key
6. [. . . ] If any dirt or foreign substances adhered on the contacts, they can be removed with a clean and dry cloth. Do not expose the front panel to high temperatures or direct sunlight in anywhere. benzene, thinner, or insecticides) from touching the surface of the front panel. Do not attempt to disassemble the front panel.
Release Button
Front Panel
2. Keep front panel into the case.
Protective Case
Front Panel
INSTALL THE FRONT PANEL
To install the front panel, insert the panel into the housing and make sure the panel is properly installed. Otherwise, abnormality occurs on the display or some keys will not function properly.
6
WIRING CONNECTION
MAIN UNIT
ANTENNA CONNECTOR FUSE RED IGNITION SWITCH (ACC+) Constant 12 volts GROUND (B) YELLOW BLACK FUSE
(BLACK) AUX IN CABLE Rch RED Lch WHITE
FRONT RCA CABLE
(BROWN) Rch RED Lch WHITE (GREY)
POWER ANTENNA FRONT Lch SPEAKER
BLUE
REAR RCA CABLE
Rch RED Lch WHITE
WHITE WHITE/BLACK
GREY GREY/BLACK VIOLET VIOLET/BLACK
FRONT Rch SPEAKER
REAR Lch SPEAKER
GREEN GREEN/BLACK
REAR Rch SPEAKER
7
OPERATION
LOCATION OF KEYS
20 1
3
12 13
5
19
17
496
10
21 7
8
14
15
16
2
18
11
22
8
OPERATION
GENERAL OPERATION
· ON/OFF Switch on the unit by pressing any button (except REL button (6) and button (4)). · FACEPLATE RELEASE Press REL button (6) to detach the removable faceplate. · LOUDNESS For the unit with two bands only: Press and hold BND/LOU button (8) for several seconds to show the loudness state. In CD mode or AUX mode, press BND /LOU button (8) shortly to show the loudness state. · SET THE CLOCK Press DSP button (9) shortly to switch display mode according to display priority set mode. Press and hold DSP button (9) for several seconds until the clock is shown on the display and flashes, then press VOL+/- button (20)(21) to change hours or the minutes. · SELECT AUDIO MODE Press SEL/MENU (3) shortly to change audio mode through volume, bass, treble, balance, and fader modes. When the currently displayed function has not been adjusted for several seconds, the mode shall return to volume position and display will return to normal radio, CD or AUX display.
Volume Bass Treble Balance Fader
Press the VOL+/- (20)(21) to select your setting.
BEEP ON/OFF Program power on volume level CLOCK ON/OFF while power off 12hours/24hours CLOCK/FREQ priority
· MENU SELECTION FUNCTION Hold press SEL/MENU (3) for several seconds and you will enter the menu functions then press the SEL/MENU button to select the different modes.
9
BEEP ON/OFF - When the beep is on. Program power on volume level In this mode, you can set the desired volume level when the unit turns on. CLOCK ON/OFF while power off In this mode, you can select if the clock is to be displayed while power off. NO PRI/CLOCK/FREQ priority - When select No Priority: When the frequency appears on the unit, pressing DSP button (9) will display clock and it will not return to frequency display until DSP button (9) pressed again. [. . . ] Depending on the recording status, conditions of the disc and the equipment used for the recording, some CD-Rs/CD-RWs may not be played on this unit. (See *1) *1:To have more reliable play back, please see following recommendations: a. Do not play a CD-RW which has been written for more than 5 times.
11
SPECIFICATION
GENERAL
Power Supply Requirements Chassis Dimensions Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Maximum Output Power Current Drain : DC 12 Volts, Negative Ground : 178 (W) x 163 (D) x 50 (H)mm : : : : ± 7dB ± 7 dB 40W x 4 (ch) 15 Amps. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSS 606C
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSS 606C will begin.