User manual BOSE WAVE RADIO CD

[. . . ] The Bose® Wave® Radio/CD Owner's Guide TM Safety Information WARNING: To reduce the risk of fire or electric shock, do not expose the Wave® Radio/CD to rain or moisture. As with any electronic product, use care not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard. CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED PERSONNEL. AVIS RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR AFIN DE PRÉVENIR UN CHOC ÉLECTRIQUE NE PAS ENLEVER LE COUVERCLE ARRIÈRE. IL NE SE TROUVE À L'INTÉRIEUR AUCUNE PIÈCE POUVANT ÊTRE RÉPARÉE PAR L'USAGER. [. . . ] · In source display mode, press the Time or to show the time momentarily. To adjust the display brightness - The display dims automatically to medium or low brightness, as appropriate for low light room conditions. You can adjust the brightness setting of the display for both strong light and lowest light environments, but not for the medium light setting. · In a strongly lit room, hold down CD Mode and press Volume L or M to adjust the setting between 5 and 9 (it is preset to 8). and press Volume L or M to adjust the · In a barely lit room, hold down CD Mode setting between 1 and 5 (it is preset to 2). · If you do not want the system to dim automatically, set both levels to 5. To turn off the display - With the system off, hold down CD Mode and press On/Off to turn off the main display. The display only lights briefly when you press any buttons and while the alarm is sounding. To check the volume setting when it is not displayed - With the system off or on, hold down Alarm Setup and press Volume L or M to see the current volume setting. To check the CD time or radio station frequency when it is not displayed With the system on, hold down Alarm Setup and press Track/Tune or to see the CD time or station frequency. To check the time when it is not displayed - With the system on or off, press the or briefly to see the current time. Time hold and press Alarm Setup On/Off Alarm Setup 1 2 Time Time CD Mode CD Mode On/Off Alarm Setup Track/Tune Alarm Setup Time Time 15 Operating Your Wave® Radio/CD Time Time Controlling the system Stop Alarm Alarm 1 On/Off Alarm Setup Presets Alarm 2 On/Off On Off 3 Sleep Volume 1 2 4 5 Track/Tune 6 CD FM CD Play CD Stop CD Mode AM AUX FM AM AUX Volume Track Tune Mute Function To turn on/off - Press On/Off once to turn on or off. To listen to a component connected to AUX, be sure to turn on the component. To adjust the volume - With the system on or off, press and hold either button to reset the volume. To mute the sound - Using the remote control only, press to silence the system. To shut off automatically - Press Sleep/Snooze or Sleep to set sleep time (timed shutoff). · When sleep time is first set, the display shows :I0 (minutes). · Press again, or press and hold, to increase the sleep time by 10-minute increments, up to :90. After :90, the next press returns to the sleep OFF setting, then begins again at :I0. · Your selected sleep time is held in memory for the next use of both sleep and nap timer. To turn on automatically (as a nap timer) - Before setting the nap timer, select your source and make sure that a radio station is tuned in or a CD is in the player. Then, on the control panel only, hold down Alarm Setup and press Sleep/Snooze to set the nap timer (to count down and turn system on). [. . . ] For information on replacing the remote control battery, see "Setting up the remote control" on page 8. Technical information Power rating 120V~ 50/60 Hz 50W Dimensions 14"W x 81/2"D x 43/8"H (35. 6 cm x 21. 6 cm x 11. 1 cm) Weight 7. 4 lb (3. 4 kg) 22 Maintaining Your Wave® Radio/CD Troubleshooting Problem System does not function What to do · Make sure the power cord is fully plugged into an operating AC wall outlet. · · · · · · · · · · Increase the volume. Check for interference from room lighting or sunlight, or for dust or dirt on the lens. Try the system in a different location. No sound Remote control is inconsistent or does not work AM reception is weak · Adjust the internal AM antenna by turning the Wave Radio/CD slightly to one side or the other. [. . . ]