User manual BOSE WAVE MUSIC SYSTEM MULTI-CD CHANGER

[. . . ] CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The multi-disc player should not be adjusted or repaired by anyone except properly qualified service personnel. This CD changer is classified as a CLASS 1 LASER PRODUCT according to !Where the mains plug is used as the disconnect device, such disconnect device shall remain readily operable. [. . . ] Plug the changer power cord into the AC power input connector on the back of the Wave® music system. Plug the Wave® music system AC power cord into the AC power input connector on the back of the changer. Plug the other end of the AC power cord into an AC (mains) wall outlet. After applying power, "PLEASE WAIT" appears on the display for about 30 seconds while the system prepares itself for operation. For best FM reception, straighten the AC power cord as much as possible. Bose® link connector Wave® music system AC POWER input Wave® music system Wave® music system AC power cord For best FM reception, straighten the power cord as much as !English An additional remote control is included with your Wave® music system Multi-CD Changer. This remote is identical to the one used to control your Wave® music system. So, you can use either remote to control the completed multi-CD system. The following diagram describes the buttons used for playing CDs using the disc changer. Press to hear audio from an external source connected to either the AUX 1 or AUX 2 input on the changer (page 12). Note: Press-and-hold operations require holding the button down for at least one second. Note: Pressing FM/AM, CD, or AUX automatically turns on the Wave® music system to the source selected. note: While the Multi-CD changer is connected , you cannot change the Alarm Time if AM radio is selected. To change Alarm Time, please select a source other than AM or turn the system off. Throughout this owner's guide you will see button icons to the left of the operating instructions. Turning your multi-CD system on and off Press On/Off once to turn your multi-CD Wave® music system on or off. If the system is off or in the CD source mode, the first disc loaded starts playing automatically. Loading CDs into the Wave® music system (Disc 1) Insert the disc, label side up, into the CD slot below the display. With your fingers on the outside edge of the disc, push the disc all the way into the slot. You can unload discs while the system is off or in the CD source mode. After removing the disc from its slot, the system moves to the next available disc which then can be ejected by pressing Stop/Eject again. [. . . ] A CD is playing, but none of the Multi-CD Changer LEDs are lit · Check to see if the CD slot in the Wave® music system is selected, instead of a slot in the Multi-CD Changer. English What is covered: All parts defective in material or workmanship. What we will do: We will, at our sole option, repair or replace any defective parts free of charge. Properly pack the unit, if possible, in the original carton for shipping. [. . . ]