User manual BOSE WAVE PC SYSTEM USB ADAPTER INSTALLATION GUIDE

[. . . ] · Consult the dealer or an experienced radio/TV technician for help. This product complies with the Canadian ICES-003 Class B specifications. ©2001 Bose Corporation. No part of this work may be reproduced, modified, distributed or otherwise used without prior written permission. Bose®, Wave®, Wave/PCTM and the Wave® radio design are registered trademarks of Bose Corporation. [. . . ] Figure 2 USB adapter connections Sound card output USB port Wave/PCTM unit DIN socket Computer 1. If your Wave/PCTM system was previously installed, remove the original Wave/PCTM system cable connecting the Wave/PCTM unit to your computer. Plug the DIN connector of the USB adapter into the DIN socket on the rear of the Wave/PCTM unit. Plug the mini-stereo plug into the audio output of your computer's sound card. Plug the USB connector into your computer's USB port. This action launches the Windows "Add New Hardware Wizard. " Completing this installation from this point depends on what operating system your computer is using: For Windows 98SE systems, see "Adding new hardware to Windows 98SE systems" on page 6. For Windows ME systems, see "Adding new hardware to Windows ME systems" on page 8. For Windows 2000 systems, see "Adding new hardware to Windows 2000 systems" on page 8. 2. 4. 5 Installation Procedure Adding new hardware to Windows 98SE systems If you are installing the USB adapter on a Windows 98SE system, three drivers will be installed during this procedure: · USB composite device driver · USB human interface device driver · USB audio device driver 1. After connecting the USB adapter to your computer's USB port, the "Add New Hardware Wizard" opens to begin searching for the USB composite device driver. When the wizard asks you, "What do you want Windows to do?, " select "Search for the best driver for your device" and click Next (Figure 3). The next window (Figure 4) asks you to specify other locations to include in the search for the device driver. Figure 4 Window for selecting search locations 6 Installation Procedure D. When Windows tells you it has finished the driver installation, click Finish. The "Add New Hardware Wizard" tells you it is ready to search for the USB human interface device driver. When the wizard asks you, "What do you want Windows to do?, " select "Search for the best driver for your device" and click Next (Figure 3). The next window asks you to specify other locations, in addition to your hard drive, to include in the search for the device driver. Leave all boxes unchecked and click Next to start the search (Figure 4). When Windows tells you it has finished the driver installation, click Finish. The "Add New Hardware Wizard" tells you it is ready to search for the USB audio device driver. When the wizard asks you, "What do you want Windows to do?, " select "Search for the best driver for your device" and click Next (Figure 3). The next window asks you to specify other locations, in addition to your hard drive, to include in the search for the device driver. [. . . ] Figure 6 "General" setup window Audio output device selection 9 Audio Settings When your system volume setting changes When you installed the new Wave/PCTM system software, a volume calibration was automatically performed. This calibration matched the relative volume level of the computer-generated audio with the audio volume of the Wave/PCTM system unit. If you change the volume level on your computer (such as in the Task bar) outside of the Wave/PCTM system application, these volume levels no longer match. If the volume levels are unmatched, the next time you open the Wave/PCTM system application a dialog box appears (Figure 7) giving you the following options: · "Set PC volume controls to calibrated values": Resets the volume controls to the settings obtained from the last automatic volume calibration. [. . . ]