User manual BOSE IN-EAR HEADSET

[. . . ] The complete Declaration of Conformity can be found at http://www. Bose. com/compliance. Clothing clip Adjustment slider Ear tips Large (black) Medium* (grey) Small (white) *Headset comes with medium ear tips attached WARNING: DO NOT use mobile phone adapters to connect headset to airplane seat jacks as this could result in personal injury such as burns or property damage due to overheating. Remove and disconnect immediately if you experience warming sensation or loss of audio. No part of this work may be reproduced, modified, distributed, or otherwise used without prior written permission. All trademarks referenced herein are property of Bose Corporation. Lanyard Carrying case English Connecting to a mobile phone or audio device You can connect the headset to your mobile phone with either the 3. 5 mm stereo plug (compatible with standard headphone jacks) or by using one of the three included 2. 5mm adapter cables if needed. [. . . ] Do not attempt to wear the headset without the ear tips. Answering calls When you receive an incoming call, press and release the Answer/End button to answer. Ending calls When you are ready to end your call, press and release the Answer/ End button. Correct Incorrect Changing ear tips Note: Some unique phone and music playback functions, like last number redial, voice commands, and track navigation are devicedependant, and may be accessible using the Answer/End button. Refer to your mobile phone user's manual to find out what features are available. Gently remove the existing ear tip by peeling up from its large rounded side. Press the ear tip securely into place until you feel it latch. English Adjusting for comfort and stability There are several ways you can change your headset to provide additional comfort and stability. Using the adjustment slider, the clothing clip, and lanyard stability accessories, you can customize how you wear your headset. Using the lanyard The included lanyard provides additional stability to your headset. You can use the lanyard on its own, or with the clothing clip for even greater stability. Attach the headset cord through the right (R) and left (L) lanyard connectors below the microphone and approximately 10 inches (25. 4 cm) below each ear piece. Pull the lanyard over your head and allow it to rest behind your neck. Adjust the lanyard connectors have enough slack above the lanyard connectors so that any downward pulls on the plug end of the cord are not felt in the ears. Note: Lanyard has a built-in safety release that separates when forcefully pulled. Using the adjustment slider Move the adjustment slider up or down to reduce or increase the amount of loose cord between the left and right earpiece. Finding the right position for the slider can help optimize the placement of the Answer/End button and integrated microphone. Using the clothing clip Use the clothing clip to fasten the cable to your clothing, for convenience, stability, and to help manage the cable. This can be helpful during high-movement activities or when using the headset in a single earpiece configuration. The clothing clip should be attached below the Y-joint and be positioned to allow natural head movement, while keeping the microphone near your mouth. English Troubleshooting If you experience any trouble using your headset, try the following troubleshooting instructions. If you still need help, see the contact information on the inside back cover for assistance in your area. Problem No audio/Intermittent Sound is coming from only one earpiece Incoming call ring tone not heard through headset Excessive bass Low volume/poor audio Microphone is not picking-up sound What to do Make sure that the headset plug is securely connected to the headphone/headset jack (not the line out jack). Make sure you are using the correct mobile phone adapter and that it is securely connected. Make sure your phone is set to pass the ring tone through to the headset. Turn off any "sound checker" or other audio signal altering features on the audio source. · Make sure you are using the correct mobile phone adapter and that it is securely connected. · Make sure the microphone is not being blocked or covered The microphone is located on the back of the Answer/End button (you may notice the small opening for the microphone). Make sure you are using the correct mobile phone adapter and that it is securely connected. [. . . ] What you must do to obtain Limited Warranty Service: Return product, with proof of purchase from an authorized Bose dealer, using the following procedures: 1. Visit http://global. Bose. com or contact your local authorized Bose dealer to identify the location of the nearest authorized Bose service facility; 2. Contact the authorized service facility for specific return and shipping instructions; 3. Label and ship the product, freight prepaid, to the address provided by the authorized service facility; and 4. [. . . ]