User manual BOSE ACOUSTIC WAVE MUSIC SYSTEM II 5-CD CHANGER

[. . . ] Please take the time to follow the instructions in this owner's guide carefully. It will help you set up and operate your system properly and enjoy all of its advanced features. WARNING: To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. WARNING: The apparatus shall not be exposed to dripping or splashing, and objects filled with liquids, such as vases, shall not be placed on the apparatus. [. . . ] Elegant integrated pedestal design ­ Using the same table-top space as the Acoustic Wave® music system II, the CD changer complements the elegance and simplicity of the system. Multiple source switching ­ Using the rear-panel auxiliary (AUX) input jacks, you can enjoy listening to one or two other audio sources in your home through the Acoustic Wave® music system II. The original packing materials provide the safest way to transport your new multidisc changer. Notify Bose Customer Service immediately (see phone numbers on the inside back cover). WARNING: To avoid danger of suffocation, keep the plastic bags out of the reach of children. Now is a good time to record the serial number of your Acoustic Wave® II CD changer here and on your product registration card. Serial number: _____________________________ Purchase date: _________________________________________ We suggest you keep your sales receipt and a copy of your product registration card together with this owner's guide. English The Acoustic Wave® II CD changer is designed to fit under your Acoustic Wave® music system II. Before you connect the two, however, select a good location for the stacked units. When choosing the location, remember that the tonal quality of your Acoustic Wave® music system II, as with any high-performance sound system, will vary with room placement. Feel free to try different locations, but keep the following guidelines in mind: · The Acoustic Wave® music system II is designed to sound best when placed on a shelf, counter, desk, or table top, 30 to 48 inches (75 to 120 cm) from the floor. The CD player in the Acoustic Wave® music system II needs an allowance of several inches for the CD cover on top of the music system to open. The Acoustic Wave® music system II should be near the center of a wall and 6 inches (15 cm), or less, away from the wall. To increase the bass response, move the unit toward any corner of the room; to decrease bass response, move it away from the corner. Seating your Acoustic Wave® music system II on the CD changer With the CD changer in your chosen location, carefully set your Acoustic Wave® music system II on top of the CD changer (Figure 2a). Make sure the Acoustic Wave® music system II fits onto the raised guides on top of the CD changer. Make sure the Acoustic Wave® music system II sits flat and the side edges of both units are aligned. Make sure there is a clear optical path in front of the unit to allow the infrared emitters and receivers to communicate (Figure 2b). English Before you start this setup procedure, disconnect the AC power cord on your Acoustic Wave® music system II and set it aside. On the back of the CD changer there are two cables that connect to your Acoustic Wave® music system II. Español Insert the two connectors of the AUX input cable into AUX IN jacks on the back of the music system (Figure 3). Be sure to match the colors of the connectors and jacks: red to red, and white to white. [. . . ] Replace only with a lithium CR2032 or DL2032 3-volt battery by Duracell, Eveready, Energizer, Maxell, New Sun, or Toshiba (available from most electronics stores). wARNING: Mishandling the remote control battery may cause a fire or chemical burn. Do not recharge, disassemble, heat above 212 °F (100 °C), or incinerate the battery. English Problem No system operation No sound or sound is muffled Español What to do · Make sure the power cord for the Acoustic Wave® II CD changer is completely plugged in both at the changer jack and at the wall outlet. [. . . ]