User manual BOSE 802 II LOUDSPEAKER BROCHURE

[. . . ] Bose 802 Series II Loudspeaker ® ® General Description The Bose 802 Series II sound components provide a fully modular system designed for high quality reinforcement of voice and music. Bose 802 Series II loudspeakers work with the 802 C Series II systems controller for active equalization of the system. The 802 Series II loudspeaker is preferred for applications requiring a rugged, portable enclosure, but can be used in permanent indoor sound system installations. [. . . ] It also provides automatic output muting on turn-off, and a secure rear-panel operating mode switch. REFER TO YOUR INSTRUCTION MANUAL FOR PROPER INSTALLATION AND OPERATING PROCEDURES. CAUTION AVIS RISK OF ELECTRICAL SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR MODE SWITCH GUIDE POSITION OPERATING MODE 2-WAY WITH LOW FREQUENCY OPTION (NOT USED) STANDARD 2-WAY (WITH 502B) VOICE ONLY/FULL RANGE (WITH 502A) 4 3 1 2 TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK WARNING: DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. INPUT MODE INPUT LEVEL ­10 +4 HIGH FREQ OUTPUT PIN 1 GRN PIN 2 + PIN 3 ­ . . . LOW FREQ LEVEL . 0 . LOW FREQ OUTPUT OUTPUT MODE SUM NORM 230V~AC 50/60Hz 12W CH 1 PIN 1 GRN PIN 2 + PIN 3 ­ CH 2 NC 3 ­10 +4 2 BA 1 FR PROTECTED BY U. S. PATENT 3, 038, 964 INPUT LEVEL OPT 4 -18 +3 CH 1 CH 2 CH 1/SUM PIN 1 GRN PIN 2 + PIN 3 ­ CH 2 TÜV Rheinland geprüdfte Sicherheit the loudspeaker shall be 240 Watts continuous pink noise, band limited from 50Hz to 16kHz. ® . . INPUT B INPUT A INPUT B INPUT A BRIDGE 220 V~ MADE IN USA CAUTION In order to grant a secure operation do not mount the amplifier in a fully closed housing. ACHTUNG: Um sichere Funktion zu gewährielsten, Gerät nicht in vollständig geshlossenes Gehäuse einbauen. Bose Corporation, Framingham 01701, Mass, U. S. A. Made in Germany Serial No. : ® Figure 1 Beamwidth vs Frequency (Bose 802-II) The loudspeaker shall be provided with a ducted vent system, tuned at 55Hz. The input connectors of the 802 Series II loudspeaker shall consist of two (2) parallel-wired 1/4 inch (6. 3 mm) phone jacks and two parallel-wired male XLR connectors. The loudspeaker enclosure of the 802 Series II loudspeaker shall be composed of mica-reinforced polyethylene copolymer structural foam. Outer dimensions of the 802 Series II loudspeaker shall be 13 " (H) x 20 1/2 " (W) x 12 1/2 " (D) (33 x 52 x 32 cm); its weight shall be 31 lb (14 kg). The loudspeaker system shall be supplied with a separate systems controller, to be connected before the input(s) of the system power amplifier(s). The fixed, 2-channel systems controller shall provide active electronic equalization and crossover functions. It shall include an operating mode switch, input sensitivity switch, low-frequency output level control, and mono sum switch. The systems controller shall use screwtype terminal strips for balanced input and output wiring connections. Outer dimensions of the systems controller shall be 1 3/4" (H) x 19. 0 " (W) x 8. 0 " (D) (4 x 48 x 20 cm). It shall fit in the single space of a standard 19 " equipment rack for mounting. The electronic controller shall be the Bose 802 C Series II systems controller. Systems Controller Technical Information Audio channels Two Operating modes Full-range, bi-amp, option (w/option card) Rear panel connectors B alanced in-out x 2 (XLR) B alanced high-frequency output x 2 (XLR) B alanced low-frequency output x 2 (XLR) Crossover 140Hz with 502B bass enclosure 125Hz with O C -1 option card Rear panel controls Mode switch Input sensitivity switch x 2 (-10dB-V, +4dB-V) B ass level control (range -18d B, +3d B) B ass mono switch (norm/sum) Electrical specifications C hannel separation: >60d B @ 1kHz Input impedance: 2. 4k nominal Output impedance: 600 nominal Output level: 8. 0V RMS max. into 600 Mechanical specifications Dimensions: 1 3/4" (H) x 19. 0 " (W) x 8. 0 " (D) (4 x 48 x 20 cm) Weight: 5. 5 lb (2. 5 kg) Figure 2 For information on the 502 ® B and 502B P Acoustimass® enclosure, refer to the technical data sheet for those products. [. . . ] The nominal horizontal beamwidth shall be 120 degrees, and the nominal vertical beamwidth shall be 100 degrees. The power handling capacity of Product C E is compliant for EM C and Safety. Warranty Information The Bose 802 Series II loudspeaker is covered by a 5-year, transferable limited warranty. The Bose 802 C Series II systems controller is covered by a 2-year, transferable limited warranty. Figure 3a Figure 3b © 199 6 B ose C or p oration, The Mountain, Framingham, MA 01701- 916 8 U SA JN94532 P N177918 Rev. 05 AM177918 Rev. 05 P C 010248 [. . . ]