User manual BOSE 2.2 DIRECT REFLECTING

[. . . ] Read these instructions ­ for all components before using this product. Do not use this apparatus near water or moisture ­ Do not use this product near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, or anywhere else that water or moisture are present. Clean only with a dry cloth ­ and as directed by Bose Corporation. Install in accordance with the manufacturer's instructions ­ To ensure reliable operation of the product and to protect it from overheating, put the product in a position and location that will not interfere with its proper ventilation. [. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time ­ to prevent damage to this product. Servicing is required when the apparatus has been damaged in any way: such as power supply cord or plug is damaged; liquid has been spilled or objects have fallen into the apparatus; the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped ­ Do not attempt to service this product yourself. Opening or removing covers may expose you to dangerous voltages or other hazards. Please call Bose to be referred to an authorized service center near you. To prevent risk of fire or electric shock, avoid overloading wall outlets, extension cords, or integral convenience receptacles. Do not let objects or liquids enter the product ­ as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Use proper power sources ­ Plug the product into a proper power source, as described in the operating instructions or as marked on the product. Information about products that generate electrical noise If applicable, this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. Set the audio device to slightly below full volume, then Insert your iPod into the dock. Set the audio device to slightly below full volume, then Note: The SoundDock remote cannot control any device connected To enable the other device to play through the system, When the remote stops operating or its range seems reduced, it is time to change the remote battery. To remove the universal insert, put your fingernail (as shown) in the slot (or gently use a thin object) and pull up. Using a coin, turn the battery cover Replace with a new battery (CR2032 or DL2032). The troubleshooting table below should help solve operating problems with your SoundDock® system. However, before proceeding to the troubleshooting table, do the following: · Remove your iPod from the dock and check for obstructions on the connectors in the dock and on your iPod. Make sure the system is plugged in, your iPod or other audio device is turned on, and audio is playing. Remove your iPod from the dock, wait five seconds, then firmly reseat the iPod in the dock. ⷠUnplug the power cord for one minute, then plug it back in. This resets the system (you should hear a tone when the system is powered back on). Your iPod does not navigate playlists using the remote Make sure there are no empty playlists on your iPod. [. . . ] If it works there, check for interference from bright room lights or sunlight. Wipe off the small lens on the front end of the remote with a clean, dry cloth. ⷠMake sure there is a clear pathway between the remote lens and your SoundDock system. Your SoundDock does not respond to any controls Unplug the power cord for one minute, then plug it back in. [. . . ]