User manual BOSCH WVD24460GB

[. . . ] Wash + Dry Avantixx en Operating and Installation Instructions Please read the operating and installation instruction supplied and handle the appliance accordingly. Table of Contents Operating instructions Information concerning waste disposal . 52 Installation instructions Installing, connecting and transporting . 53 2 The new washer-dryer which you have just purchased is a modern, high-quality domestic appliance. Your washer-dryer is distinguished by its economical consumption of energy, water and detergent. [. . . ] – Touch the Start/Pause A button. 32 ² If the programme sequence is changed by rotating the programme selector or the programme is cancelled, the preselected finish in time is also cancelled. The programme duration of the newly selected programme appears in the display. The finish in time must be reselected (see also chapter "Changing the programme", page 36 and "Cancelling the programme", page 36). ² The laundry can be topped up at any time during the finish in time. Close the washer-dryer door. 33 Childproof lock You can secure your washer-dryer to prevent selected functions from being inadvertently changed. If the childproof lock has been selected: – no changes can be made while the programme is running, – the symbol @ flashes if a programme setting is inadvertently changed, – should the appliance be switched off and on while a programme is running, the programme will continue at the point at which it was interrupted, – when the programme ends, the duration time is showed as 0:01, the loading door cannot be opened, deactivate the childproof lock, the door can be opened while the display shows -0-. Activating the childproof lock ■ Set the programme selector to the required programme and, if required, select other settings. The programme starts. ■ ■ ² Release the Start/Pause A button. Example of Easy-Care 40 °C programme: ■ Touch the 5 button and hold down (for approx. Release the 5 button, the childproof lock is activated, the symbol is permanently on. ■ 5sec. Deactivating the childproof lock The childproof lock should be deactivated before making programme changes or ending programmes at selected programme. When a different programme has been selected, the @ symbol will continue to flash and the childproof lock can be deactivated. But the running programme will be terminated and return to ready state. ■ Touch the 5 button and hold down (for approx. 5 seconds) until the @ symbol goes out. ² If there is a power failure, the childproof lock remains on. 34 Signal The acoustic signal indicates: – that the additional functions (buttons) have been switched on or off. start of programme, end of programme), operating errors and faults. Start the signal mode 1. One step to right Set volume for. . . 5. release and find the number from 0 to 4 6. Information signals* ■ After setting, run the programme selector to “Off”, the volume of signal is stored * If required, set repeatedly. 35 During washing/drying Changing the programme If you have accidentally selected the wrong programme ■ If the childproof lock is active, temporarily deactivate, see page 34. If required, re-activate the childproof lock, see page 34. ■ ■ ■ Cancelling the programme If you would like to terminate a programme and remove the laundry: ■ If the childproof lock is active, deactivate, see page 34. Turn the programme selector to Drain [, Spin Í or Rinse '. If required, select the desired spin speed (but not setting “$” (without final spin)). ■ ² If a programme is interrupted at a high temperature, Rinse ' should be selected to cool down the laundry. ■ For drying programme, select time-dry 15 min cooling programm to cool down the laundry. Turn the programme selector to Off. ■ ■ ■ ■ ■ 36 ■ ■ Open the washer-dryer door. Remove the laundry. ² If a programme was interrupted at a high temperature, such as drying programme, please do no open the washer-dryer door until the appliance has cooled down. Pausing the programme If you would like to pause a runing programme without changing the sequence: ■ Touch the Start/Pause A button during washing cycle, the display shows "PAUS" (pause), if door open symbol } flashes at this moment means the door can be opened after 1 minute later, when the } symbol and "OPEn" come on, open the door if required, add/remove the laundry, close the door. To continue the programme touch the Start/Pause A button again. ■ ² The pause function cannot be activated during drying cycle and water pressure detecting period. If a programme was paused at a high water level or temperature, the door open symbol does not appear. 37 When the programme has ended ² Display panel: – All symbols on the programme status display have gone out, washing temperature, spin speed are displayed, – The programme duration is shown as -0-, – If the childproof lock is selected, the @ symbol is lit and the programme duration is shown as 0:01. [. . . ] To prevent leaks or water damage, it is essential to follow the instructions in this chapter!Do not connect to the mixer tap of an unpressurised hot-water apparatus. Only use the inlet hose supplied or one which was purchased from an authorised specialist dealer. The water inlet hose must not be – kinked or crushed, – modified or severed (strength is no longer guaranteed). [. . . ]