User manual BOSCH TDA7630

[. . . ] € This appliance is to be connected and used in accordance with the information stated on its characteristics plate. If it is absolutely necessary to use an extension cable, make sure that it is suitable for 16A and has a socket with an earth connection. € If the safety fuse fitted in the appliance blows, the appliance will be rendered inoperative. To restore normal operation the appliance will have to be taken to an authorised Technical Service Centre. [. . . ] € Turn the temperature control dial down and wait until the iron has cooled down. € Turn the temperature control dial regulator to a higher position and wait until the operating indicator switches off. Getting ready (1) (2) (3) (Model dependent) The “Secure” auto shut-off function switches off the iron when it is left unattended, thus increasing security and saving energy. After plugging in the appliance, this function will be inactive for the first two minutes in order to give the appliance time to reach the set temperature. Alter such time, if the iron is not moved for 8 minutes while in the upright position or 30 seconds while resting on its soleplate or on its side, then the safety circuit will switch the appliance off automatically and the pilot light will start flashing. Ironing without steam Only when the temperature control dial is placed in the areas with the steam symbol. Ironing with steam (Model dependent) If the temperature is set too low, the steam is automatically switched off to avoid dripping. (Model dependent) The “e” steam setting (energy saving “e” setting: 24% energy saving*) can be used for most fabrics. The steam settings should only be used on thick fabrics where there are still wrinkles. Steam setting e Proenergy (Model dependent) You are recommended to start by ironing a small area on the reverse of the garment, to ensure that the iron setting is correct. To fit the fabric protection cover to the iron, fit the tip of the iron inside the tip of the fabric protection cover and press the lower section of the fabric protection cover until you hear a click. To remove the fabric protection cover, pull on the rear tab and remove the iron. The protective cover can be purchased from After-sales or specialist outlets. Accessory code (After-sales) 464851 Name of accessory Specialist outlets TDZ1510 Fabric protection cover (10) Smoke comes out when connecting the iron for the first time. € •• ••• Synthétiques Soie- laine Coton – lin You can download this manual from the local homepages of Bosch Remplissage du réservoir d'eau Réglez le régulateur de vapeur sur la position et débranchez le fer à repasser de la prise de courant !*in comparison to the maximum steam setting of a regular 2400 Watt max Bosch iron Note: At a temperature setting of “•”, the soleplate is not hot enough to produce steam so the steam regulator should be set to the position to avoid water dripping from the soleplate. Storing Set the steam regulator to the position Cleaning Tips to help you save energy (12) Avertissements importants Préparation pour le repassage Repassage sans vapeur Repassage à la vapeur (1) (2) (3) Do not use the spray function with silk. Set the temperature control dial to at least the "•••" position Interval between shots of steam should be 5 seconds. With the iron unplugged, fill in the tank of the iron with tap water and set the temperature control dial to “max” Plug in the appliance to the mains. When the steam iron has reached the desired temperature (pilot light switches off), start steaming by setting the steam regulator to the maximum steam setting and by repeatedly pressing the button . When using the steam function for the first time, do not apply it on the laundry, as there could still be dirt in the steam dispenser. When turned on for the first time, your new iron may smell and emit a little smoke and a few particles; this will stop after a few minutes. [. . . ] € Regulate the steam according to the selected ironing temperature, following the instructions in this manual. € Try to Iron the fabrics while they are still damp and reduce the steam setting. If you tumble dry your fabrics before ironing them, set the tumble drier on the ‘iron dry’ programme. € If the fabrics are damp enough, turn off the steam regulator completely. [. . . ]