User manual BOSCH SMV69T20GB

[. . . ]         K  PLQ K K 6WDUW $ % &  5HVHW  VHF              en Table of contents Intensive zone . 16 16 16 16 16 16 17 17 17 17 18 18 18 18 19 19 19 19 19 20 20 21 21 22 22 22 23 23 24 24 24 25 25 25 25 25 26 26 26 27 27 27 27 27 Safety instructions . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. [. . . ] – Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display 8. To change the setting: – By pressing the button 3, you can switch the function off : or on : . – Close the door. End of programme The programme has ended when the value : is indicated on the numerical display 8. – Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display 8. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). – Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 8. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 17 en Automatic switch off after end of programme or interior light* gitlho/iterntfAom hcsua iw Switching off the appliance Short time after the end of the programme: – Open the door. – Remove the utensils when they have cooled down. * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. Appliance switches off after 120 min. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme – Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. – To continue the programme, switch on the ON/OFF switch ( again. – Close the door. nrem Tiatghpo : : – Open the door. – Hold down programme button # and press START button )" until : . . . [. . . ] The hot water setting : allows you to adjust your appliance optimally to operation with hot water. It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C. It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler. – Hold down programme button # and press START button )" until : . . . [. . . ]