User manual BOSCH SKS50E01EU INSTALLATION INSTRUCTIONS

[. . . ] The factory set value H:04 is lit on the digital display. 2 * only before the first wash or if the water hardness has been changed 0-8 9-10 11-12 13-15 16-20 21-26 27-38 39-44 0 -1. 1 1. 2-1. 4 1. 5-1. 8 1. 9-2. 1 2. 2-2. 9 3. 0-3. 7 3. 8-5. 4 5. 5-6. 2 ·:<< ·:<, ·:< ·:<, , ·:<. . . ·:< ·:< ·:<^ Start ­ Rotate programme selector B until the required value is indicated on the digital display. [. . . ] ·:< ·:< ·:<^ Start ­ Rotate programme selector B until the required value is indicated on the digital display. The set value is saved. Filling the salt dispenser Dissolves limescale (not necessary for set value 0!) . . . Unscrew cover. Wash immediately. 3 4 6 $ Adding rinse aid Spick and span . . . 2 Press mark 1, lift up cover 2. Fill in rinse aid. Screw on the cover. Attention: Combination products are not suitable for all programmes, follow manufacturer's instructions. Adding detergent A lot of dirt, a lot of detergent . . . 5 9000 451 595 (8908) 550 EG Switching on the appliance 50 ml 25 ml 15 ml Pour detergent into the dry detergent dispenser only. Slide cover shut, press. PLOP! 7 Select programme Quick, economical or intensive . . . Overview of programmes The max. The corresponding programmes for your appliance can be found on the fascia. Start Intensive 70° Auto 45°­65° Eco 50° Gentle 40° Quick 45° Prerinse ±² Duration: hs : mins Energy consumption in kWh Water consumption in litres With Aquasensor Á 1:30-2:30 0, 55 - 0, 85 6-9 áà é ê 2:40 0, 63 7 1:15 0, 45 7 6 ñð 0:29 0, 45 6 - ù ø The programme data has been measured in the laboratory according to European standard EN 50242. Stains and streaks Rinse aid dosage too high/too low Streaks: reduce dosage. Utensils not dry Rinse aid The combined detergent used has a poor drying performance Appliance setting Milky deposits on the utensils (can be removed) Milky deposits, glasses cloudy/tarnished (cannot be removed) Water softening system incorrectly set No salt Increase dosage. Refill with special salt. Display "E:25" and "6" are lit Other fault display "E:XX" is lit Waste water pump blocked Appliance has technical defect Call factory customer service (state fault display). Unplug appliance. Residual water in the appliance The programme has not yet ended Close the appliance and switch it on or terminate the programme (see Terminating the programme). Glasses not dishwasher-proof Use dishwasher- proof glasses. Use a detergent suitable for glasses. Rust on the cutlery Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Too little detergent Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). [. . . ] Use a detergent suitable for glasses. Rust on the cutlery Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Too little detergent Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). [. . . ]