User manual BOSCH PST 900 PEL 620W

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] Book Page 17 Wednesday, August 10, 2011 8:56 AM English | 17 The vacuum cleaner must be suitable for the material being worked. When vacuuming dry dust that is especially detrimental to health or carcinogenic, use a special vacuum cleaner. € For adjustment of precise mitre angles, the base plate has adjustment notches on the left and right at 0°, 22. Swivel the base plate 7 to the desired position according to the scale 25. € Afterwards, push the base plate 7 to the stop in the direction of the saw blade 19. € Close the base plate clamping lever 6 to lock the base plate in the adjusted position. Cut Control for Bevel Cuts (PST 900 PEL) Operation Operating Modes Before any work on the machine itself, pull the mains plug. Orbital Action Settings The four orbital action settings allow for optimal adaptation of cutting speed, cutting capacity and cutting pattern to the material being sawed. The orbital action can be adjusted with the adjusting lever 8, even during operation. No orbital action Small orbital action Medium orbital action Large orbital action The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply: – Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge. € For soft materials and when sawing in the direction of the grain, work with maximum orbital action. Adjusting the Cutting Angle The base plate 7 can be swivelled by 45° to the left or right for mitre cuts. The dust cover 10 and the splinter guard 22 cannot be used when performing mitre cuts. If required, remove the dust cover 10 (see “Dust Cover”, page 16) and take off the splinter guard 22 (see “Splinter Guard”, page 16). PST 900 PEL (see figure G): – Pull the saw blade storage 21 out of the base plate 7. € Loosen the screw 24 and lightly slide the base plate 7 toward the vacuum connection 5. € For adjustment of precise mitre angles, the base plate has adjustment notches on the left and right at 0°, 22. Swivel the base plate 7 to the desired position according to the scale 25. € Afterwards, push the base plate 7 to the stop in the direction of the saw blade 19. PST 1000 PEL (see figure H): – Release the base plate clamping lever 6 and lightly push the base plate 7 in the direction of the vacuum connection 5. ˚ 45 ˚ , 5 22 0˚ 29 12 13 7 30 For cutting-line control of bevel cuts, the “Cut Control” viewing window 12 has a mark 29 for 0° right-angle cuts and a mark 30 each for the left- or rightward sloping 45° bevel cut according to scale 25. [. . . ] Exploded views and information on spare parts can also be found under: www. Com Our customer service representatives can answer your questions concerning possible applications and adjustment of products and accessories. Disposal The machine, accessories and packaging should be sorted for environmental-friendly recycling. Only for EC countries: According to the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. [. . . ]