User manual BOSCH PBH 2100 SRE

[. . . ] Book Page 16 Friday, November 19, 2010 2:46 PM 16 | English Safety Notes en General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] For different voltages and models for specific countries, these values can vary. Book Page 20 Friday, November 19, 2010 2:46 PM 20 | English Adjusting the Drilling Depth (see figure B) The required drilling depth X can be set with the depth stop 12. € Press the button for the depth stop adjustment 9 and insert the depth stop into the auxiliary handle 11. € Insert the SDS-plus drilling tool to the stop into the SDS-plus tool holder 1. Otherwise, the movability of the SDS-plus drilling tool can lead to incorrect adjustment of the drilling depth. € Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. Declaration of Conformity We declare under our sole responsibility that the product described under “Technical Data” is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 2006/42/EC. 2010 Selecting Drill Chucks and Tools For hammer drilling and chiselling, SDS-plus tools are required that are inserted in the SDSplus drill chuck. For drilling without impact in wood, metal, ceramic and plastic as well as for screwdriving, tools without SDS-plus are used (e. For these tools, a keyless chuck or a key type drill chuck are required. Auxiliary Handle Operate your machine only with the auxiliary handle 11. Changing the position of the auxiliary handle (see figure A) The auxiliary handle 11 can be set to any position for a secure and low-fatigue working posture. € Turn the wing bolt for adjustment of the auxiliary handle 10 in anticlockwise direction and set the auxiliary handle 11 to the required position. Changing the Key Type Drill Chuck To work with tools without SDS-plus (e. , drills with cylindrical shank), a suitable drill chuck must be mounted (key type drill chuck or keyless chuck, accessories). € Insert the chuck key into the corresponding holes of the key type drill chuck 13 and clamp the tool uniformly. € Turn the mode selector switch 8 to the “drilling” position. Dust Extraction with the Dust Extraction Attachment (Accessory) Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be harmful to one’s health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or bystanders. Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-treatment additives (chromate, wood preservative). € As far as possible, use a dust extraction system suitable for the material. Observe the relevant regulations in your country for the materials to be worked. [. . . ] In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. Working Advice Changing the Chiselling Position (Vario-Lock) The chisel can be locked in 36 positions. In this manner, the optimum working position can be set for each application. € Turn the mode selector switch 8 to the “Vario-Lock” position (see “Setting the Operating Mode”, page 22). [. . . ]