User manual BOSCH DHI635 HX

[. . . ] 15 Instructions for use: Appliance description Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. In doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. [. . . ] Disposal of the old activated carbon filter: ❑ Activated carbon filters do NOT contain any pollutants, i. Insert the activated carbon filter from below into the extractor-hood housing and lock into position on both sides. Cleaning and care For appliances with a glass plate in the pull-out vapour extractor: ❑ The glass plate is easily removed and can be cleaned in a dishwasher. 20 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box.  At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood.  Do not scrape off any dirt that has dried on but loosen it up with a damp cloth.  Do not use abrasive cleaning agents or sponges that could cause scratches.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. stainless steel surfaces: ❑ Use a mild non-abrasive stainless steel cleaner.  Clean the surface in the same direction as it has been ground and polished. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. replace the bulb (standard filament bulb , max 60 W , E14 bulb holder). Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium, painted and plastic surfaces: ❑ Use a soft, non-linting window cloth or micro-fibre cloth. 21 Installation Instructions: Important information ṇ Old appliances are not worthless rubbish. Additional information concerning gas cookers: ṇ When installing gas hotplates, comply with the relevant national statutory regulations (e. Please ask your dealer or inquire at your local authority about current means of disposal. Always comply with the currently valid ṇ Only one side of the extractor hood may be installed next to a high-sided unit or high wall. [. . . ] The corresponding accessory numbers can be found at the end of these operating instructions. O 100 120 ṇ Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. If it is necessary to wire the extractor hood directly into the mains: The extractor hood should only be connected to the electricity supply by a properly qualified electrician. A suitable separator is a switch that has a contact gap of more than 3 mm and interrupts all poles. [. . . ]