User manual BOSCH AHS 54-20LI

[. . . ] Book Page 19 Tuesday, June 30, 2009 2:04 PM English | 19 Safety Notes en General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. B) Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators. [. . . ] 2 seconds, which acoustically indicates that the battery is fully charged. With no battery inserted, continuous lighting of the green charge control LED 12 indicates that the mains plug is plugged into the socket and that the battery charger is ready for operation. Battery Temperature below 0 °C and above 45 °C Continuous lighting of the red LED 11 indicates that the battery temperature is not within the rapid-charging temperature range of 0 °C – 45 °C. As soon as the allowable temperature range is reached, the battery charger automatically switches to rapid charging. When the battery is not within the allowable temperature range, the red battery LED lights up when inserting the battery into the battery charger. Bosch Power Tools No charging procedure possible If a different malfunction of the charging procedure is present, this will be indicated through flashing of the red charge control LED 11. The charging procedure can not be started and the battery cannot be charged (see “Troubleshooting”). Charging Advice With continuous or several repetitive charging cycles without interruption, the charger can warm up. This is not meaningful and does not indicate a technical defect of the battery charger. A significantly reduced working period after charging indicates that the battery is used and must be replaced. Battery Cooling (Active Air Cooling) The fan control integrated in the battery charger controls the temperature of the inserted battery. When the battery temperature is above 30 °C, a fan cools down the battery to the optimal charging temperature. The battery temperature is within the optimal charging temperature range when the fan is not running, or the fan may possibly be defective. Operation Initial Operation Inserting the Battery (see figure A) Insert the charged battery 8 from the rear into the handle of the garden product. Push the battery completely into the handle until the red stripe can no longer be seen and the battery is securely locked. Note: The garden product will not operate unless both locking levels are engaged. Book Page 26 Tuesday, June 30, 2009 2:04 PM 26 | English Switching On (see figure B) Press and hold the On/Off switch 6 on the rear handle. Anti Blocking The garden product has a patented feature which works as follows: If the blade stalls on a tough material, the load of the motor increases. The intelligent microelectronics senses this overload condition and repeatedly reverses the motor, in order to prevent stalling and to cut the material through. After cutting through, the garden product continues in its normal mode, or in case the overload condition continues the blades automatically stop in the open position (e. In case a piece of metal fence accidentally blocks the garden product). Sawing Function (see figure F) Although the blade gap allow wood to be cut upto Ø 20 mm, the tip of the blade is designed to cut wood up to Ø 25 mm. [. . . ] Undgå at bære el-værktøjet med fingeren på afbryderen og sørg for, at el-værktøjet ikke er tændt, når det sluttes til nettet, da dette øger risikoen for personskader. Book Page 99 Tuesday, June 30, 2009 2:04 PM Dansk | 99 Sikkerhedsforskrifter for ladeaggregater Ladeaggregatet må ikke udsættes for regn eller fugtighed. Book Page 104 Tuesday, June 30, 2009 2:04 PM 104 | Dansk Temperaturovervågning af akkuen Den røde LED-lampe 17 blinker, når der trykkes på tasten 15 eller start-stop-kontakten 6 (når akkuen er sat i): Akkuen er uden for driftstemperaturområdet fra – 10 °C til +60 °C. ved temperaturer over 70 °C slukker akkuen , til den befinder sig i det tilladte temperaturområde igen. [. . . ]