User manual BOLEX H9

[. . . ] With its quick release device it can be mounted or removed in seconds. In any case, you will find the adapter necessary if you use a Bolex tripod, which is equipped with the same quick release system. [. . . ] 2) so as to eliminate any possible source of play between the adapter and the camera base. Fitting the grip on to the camera catch (e), then that the When this lead is connected the camera will be started by depressing the trigger. As the switch does not operate until the trigger is fully depressed, it is preferable to reduce the travel of the trigger by raising lever (j). Let go of the trigger If you own a Vario-Switar The diaphragm pre-selection device grip, by using a flexible cable: 1. Screw one end of the flexible cable into the thread on the Vario-Switar pre-selection device, and the other end into the grip. (available separately) on to the and screw one end of the cable into the grip (fig. Depending on the adjustment of the cable when lever (j) is raised, the movement of the release can be reduced (for normal running) or increased, in order to be able to engage the continuous running position (for instance, to end a scene with a fadeout, using the RX-fader). If you own a Vario-Switar You can also operate the diaphragm pre-selection device from the grip, without using the electric motor, by using the flexible cable. Screw one end of the cable into the thread on selection device and the other end into the grip. The length of the cable is correctly adjusted when there is absolutely no play and when the slightest pressure on the hardgrip trigger moves the pre-selection plunger of the lens. [. . . ] Screw one end of the cable into the thread on selection device and the other end into the grip. The length of the cable is correctly adjusted when there is absolutely no play and when the slightest pressure on the hardgrip trigger moves the pre-selection plunger of the lens. [. . . ]