User manual BLUMAX GPS-4044

[. . . ] If you do not follow these rules, the battery inside Blumax Bluetooth GPS4044 Recorder may overheat, explode or burn itself, and this will lead to very serious damage. The Lithium battery inside the Blumax Bluetooth GPS-4044 Recorder should be recycled. ⷠWhile in the hospital, turning off the Blumax Bluetooth GPS4044 Recorder is recommended. [. . . ] For the 1st time you use the GPS-4044 Recorder, please charge battery until it is full (the green LED is off). ⷠWhen the Power LED is off, the battery is fully charged. Turning on the power switch Navigation Data record Power off Power Switch Right (Off) Middle (NAV) Left (LOG) Push button Push Push to log points of interest, LED blinks 3 times. Difference between NAV and LOG: You can use the GPS-4044 Recorder as a Bluetooth GPS receiver to navigate when you have a Bluetooth enabled PDA/ Smartphone in your car. Connecting your handheld device with Blumax Bluetooth GPS-4044 Datalogger. How to connect the Blumax Bluetooth GPS-4044 Datalogger to your PC (Playback your route) Step 1. For software utility how to use in detail: Refer to Help > User Manual Step 4. Build a connection between your PC and Blumax Bluetooth GPS-4044 Datalogger, see below: Or select correct COM Port, and set Baud Rate at a fixed 115200. Note: To display the track points on Google Earth, your PC must have the Internet connection enabled. Bluetooth on, but not Always on: connected to any Bluetooth devices yet Bluetooth Status LED Blue Slowly blinking: Quickly blinking: Red Green Green Blinking: Light On: Light Off: Always on: Orange GPS Status LED Blue Quickly Blinking: Quickly Blinking: Slowly Blinking: Solid Sleeping mode (1 time / 5 seconds) Bluetooth is connected and ready for data transmission (1 time / 2 seconds) The battery is too low The battery is charging The battery is fully charged Acquiring satellites, GPS position not fix GPS position is fixed, Navigation LED blinks 3 times, Points of Interest is recorded The memory space is too low (20% left now) The memory is full and stop It's better to turn off the Blumax Bluetooth GPS-4044 Datalogger when you don't use it, otherwise it might still keep recording data if you leave it in the log state. ⷠSome vehicles having heavy metallic sun protecting coating on windshields may affect GPS signal receptions. ⷠDriving in and around high buildings may affect GPS signal receptions. ⷠDriving in tunnels or indoor park garage may affect signal receptions. ⷠIn general, any GPS receiver performs best in open space where it can see clear sky. Also weather will affect GPS reception ­ rain & snow contribute to worse sensitivity. ⷠLow battery of a PDA or of an Blumax Bluetooth GPS-4044 Datalogger may affect signal receptions. ⷠPlease check the correct "COM" and "Baud Rate" of your PDA to secure the Bluetooth connection between Blumax Bluetooth GPS-4044 Datalogger & PDA. ⷠBlumax Bluetooth GPS-4044 Datalogger outputs data every second, therefore the actual position and the position shown in your map may have slight time delay. [. . . ] The stamp of distributor or a copy of the original sales receipt is required as the proof of purchase for warranty repairs. The company will, as its sole option, repair or replace any components, which fail in normal use. Such repair or replacement will be made at no charge to the customer for parts or labor. [. . . ]