User manual BLITZ BZCAPT30 INSTALL GUIDE

[. . . ] SPECIFICATIONS Model: BZCAP30 3 Farad TRIANGLE Hybrid Super Capacitor With Red Digital Voltage Display, Blue Flash LED, Blue Led Ring Capacitance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3, 000, 000 micro farad Working Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] and largest moment discharge power. 1 INSTALLATION AND MOUNTING: You must first attach the mounting tabs to the capacitor before mounting it. Notice the small mounting screw hole in the capacitor chassis. CHARGING THE CAPACITOR AND WIRING: The capacitor must be charged before connecting the Power and Ground cables to the capacitor. Failure to charge the capacitor will result in a large spark generated from the rapid inflow of current. 2 C H AR G IN G B U LB ( -- ) ( + ) B ATTER Y To Charge the capacitor: 1. Make Capacitor positive terminal connections with amplifier and tighten the bolt. Caution: Stripped terminals are not covered under the capacitor's warranty. Connect the ground cable with battery, amplifier, then refer to the attached drawing. Place the supplied charging bulb between positive terminal of the capacitor and the battery's positive terminal. Immediately take out the charging bulb from the connecting wire after the charging process. [. . . ] PLEASE REFER TO THE INSTRUCTIONS CONTAINED IN THIS MANUAL FOR CORRECT OUNTING, CHARGING/DISCHARGING AND WIRING CONNECTION FOR THIS CAPAPCITOR PRIOR TO INSTALLATION. WARNING!! 4 [. . . ]