User manual BLITZ BZ4UBKBL

[. . . ] 4TUBE UNDER CAR LIGHTING KIT INSTRUCTIONS PLEASE READ CAREFULLY BEFORE INSTALLING NEON *WARNING* 1) DISCONNECT YOUR CAR BATTERY BEFORE INSTALLING NEON TUBES 2) THIS IS A HIGH VOLTAGE SYSTEM AND MAY CAUSE BURN OR SHOCK IF NEON TUBES ARE NOT PROPERLY CONNECTED. LOOSE WIRES CAN ARC AND MAY CAUSE FIRE. [. . . ] NOTE: SOME COMPACT CARS WILL ONLY ACCEPT TUBES MOUNTED BEHIND THE GRILL OR UNDER THE BUMPER. 2) WIRING : A) TRUN OFF SURPLUS WIRE BEFORE CONNECT. MAKE SURE ALL WIRES ARE AS SHORT AS POSSIBLE , AND CLOSE TO TUBE AS ILLUSTRATED IN WIRING DIAGRAM B) ALLOW AT LEAST 2 INCHES OF CLEARANCE AF THE END OF EACH TUBE SO THAT WIRE MAY BE EASILY BENT BACK. C) MOUNT MULT-OUTLETS POWER CONNECT NEAR TO BATTERY BUT AWAY FROM ENGINE ON A FLAT METAL SURFACE. D) BLACK(GROUND) WIRES CAN BE INDIVIDUALLY SECURED TO CHASSIS , OR TO THE BATTERY(-) CAUTION: BEFORE SWITCHING ON SYSTEM , BE SURE TO SECURELY CONNECT ALL THE WIRES FROM TUBES TO BATTERY. 3) GENERAL INFORMATION: A) THE 12 VOLT ELECTRONIC NEON TUBES DRAW ONLY 6 AMPS AN8 AMP IN LINE FUSE IS PROVIDED. B) EACH PREWIRED NEON GLASS TUBE IS SEALED AND PROTECTED IN A HIGH IMPACT ACRYLIC TRANSPARENT COVER FOR INCREASED LIFE AND DURABILITY. [. . . ] C) ALWAYS CONNECT WIRES TO EACH OTHER AND SOLDER IN PLACE AND TAPE FOR BEST CONNECTIONS CONTAINS: ONE 4-TUBES KIT CONSISTING OF :4 NEON TUBES(2-3FT & 2-4FT) 1 MULTI-OUTLETS POWER CONNECTOR BLOCK, NOUNTING BRACKETS , FUSE. SWITCH AND ALL HARD WARD WIRING DIAGRAM& INSTRUCTIONS , READ INSTRUCTIONS CAREFULLY FOR SIIOW USE ONLY . [. . . ]