User manual BLAUPUNKT TRAVEL PILOT RNS3 FH

[. . . ] If there is no speedometer signal, it will be necessary to have a route sensor mounted by an authorised customer service centre. In this case you will have to order a sensor kit (route sensor, magnet strip, bracket and plug) from your dealer. [. . . ] For vehicles without a DIN compartment, Blaupunkt offers vehicle-specific installation kits for 50/52 mm units for the most popular vehicle models. Please check the installation conditions in your vehicle and use a vehicle-specific installation kit if necessary. termine which fastener tabs you can bend over with a screwdriver (see Fig. Note: Bend over as many of the fastener tabs as possible. 3. 1 Radio antenna In pre-equipped vehicles (e. g. : VW, Seat, Audi), the antenna gets its power supply via the antenna wire (see the vehicle operating instructions). If you want to replace the OEM radio with a conventional radio, you will have to order an antenna supply diplexer (Order-No. You will find information on the installation and connection of the antenna in the antenna installation instructions. 5). 4. 3 Installing the TravelPilot Push all of the plugs into the sockets until they lock into place. Apply gentle pressure to both side edges and push it in until the spring locks snap into position on the right and left (you will hear a loud click). When you push in the system, make sure that you do not put any pressure on the display, the knobs or the keys! 3. 2 GPS antenna (satellite navigation) You will find information on how to install the antenna in the enclosed antenna installation instructions. If the GPS antenna is installed inside the vehicle, we cannot guarantee that the system will function correctly. 4. 2 Installing the bracket The bracket included with this TravelPilot allows you to install the system in vehicles with a DIN car radio compartment measuring 182 x 53 x 165 mm and an instrument panel which is 1 to 20 mm in the area where the fastener tabs are located, (see Fig. For the installation, you have to push the bracket into the compartment and de- 4. 4 Removing the TravelPilot Insert the handles into the corresponding holes on the left and right side of the front panel and push them in until you hear a loud click (unlocking the side spring locks). Use both handles to carefully pull the TravelPilot out of the compartment. Now you can pull out the connection cables by applying pressure on the side of the plug (see Fig. [. . . ] Do not connect the control cable to terminal 15 (Plus connected) or terminal 30 (continuous plus). 12V Relais 8 Wheel sensor (required for vehicles without a speedometer signal only) Plus connection (connected to the ignition) terminal 15 +12V This connection must be made via the ignition (terminal 15, +12V). 8 604 390 045 A Ground Do not connect the ground wire (min. Lay the ground wire to a suitable ground (chassis screw, chassis metal) and screw it down. Speedometer signal Illumination connection Illumination connection for vehicles with variable instrument lighting (plus regulated). [. . . ]