User manual BLAUPUNKT TRAVELPILOT FREESTYLER

[. . . ] Navigation Radio CD The GPS antenna must be positioned optimally to enable precise navigation without a speed signal. Please observe particularly the installation note in point 3. 2 on page 97 and the installation test on page 90. Operating and installation instructions www. blaupunkt. com 2 Device overview 2 1 3 4 5 6 7 8 9 16 15 14 13 12 11 10 1 NAV button Short press: Activates navigation mode and the four memory banks. Long press: Opens the selection menu for traffic-jam ahead and route options. Volume control Switches the device on/off and activates/deactivates the mute volume function. [. . . ] Note: If you select dynamic navigation you can additionally choose between a quick, short or optimum route calculation. 4 Press and hold down the OK button ; for longer than 2 seconds and then press the ESC button =, or press the ESC button = twice. NAVI TMC TRAFF. If the route option is activated, a filled-in square appears next to it. ROU=E OP=ION TMC DYNAMIC FAST SHORT OPTIMUM o o NAV FM1 10 16 pm TMC NDR 2 16mi NAV The system calculates the route again and the navigation display appears. Notes: If necessary, you will be asked to insert the navigation CDROM if it is not already present in the CD drive. The system must be tuned into a TMC station during navigation in order to provide dynamic navigation. The TMC symbol flashes if the system is not tuned into a TMC station. B6, WESTSC HNELLWEG INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 43 INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 44 Recalculating the route If the TravelPilot E receives a traffic message from the TMC that is relevant to the route, it will automatically recalculate the route. The system outputs a voice announcement informing you that the route is being recalculated. Plus Point: If the speech output for traffic announcements is activated on the (see "Configuring the language and speech options" TravelPilot E in the "Setup ­ basic settings" chapter), the system will read out a detailed traffic jam announcement (if the announcement applies to the current route). Depending on the information broadcast over TMC, the TravelPilot E might (but not necessarily) work out a detour. If the system does guide you through the traffic disruption despite having recalculated the route, it will inform you of this with a voice announcement telling you that the route contains traffic disruptions. Notes: If necessary, the system will ask you to insert the navigation CDROM. Tuning into TMC stations automatically If the automatic TMC feature is activated and the system did not receive a TMC station before, the tuner will automatically tune into a TMC station when you select DYNAMIC. Note: TMC seek tuning can take a long time because the system scans the entire frequency range for TMC stations. To activate the automatic TMC feature, proceed as follows: 1 2 Press the MENU button ?. A selection menu appears in the display. 3 4 5 Mark and confirm the TMC AUTO menu item. Press the ESC button = twice to return to navigation mode. radio TMC TMC AUTO SEEK NAV Tuning into TMC stations manually To tune into a TMC station manually, proceed as follows: 1 Press the button 7 or the button 8. Reading TMC messages The TravelPilot E provides you with the option of displaying the traffic messages received via TMC (Traffic Message Channel). If no messages are stored in memory, an appropriate notice will be displayed. 2 1 2 3 Turn the menu knob : to browse through the list of available messages. If a message is longer than the display area can accommodate, Turn the menu knob : to scroll through the message. Note: To ensure that only the data that are relevant to your current vehicle position are used, the TMC function only processes TMC messages relating to an area within a radius of approx. 60 miles (100 km) around your vehicle position. =MC aU=O TMC ON OFF NAV =MC TMC 1/2 NAV A7 Hannove r Hamburg accident b etween MJ =MC TMC 1/2 NAV r Hamburg accident b etween MJ Schwarmst SETUP INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER APPENDIX 45 INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX 46 Bypassing a traffic jam during navigation Alongside the ability to automatically bypass traffic jams with the aid of the dynamic navigation feature, the TravelPilot E also gives you the option of manually entering traffic jams or blocked sections of road during an active navigation session. [. . . ] We do not accept liability for incorrect connections and their consequences. 4. 4 Connecting the reversing light signal (only TravelPilot E with speed signal) Lay a cable from the reversing light to pin 3 of chamber A (see Fig. You must make sure that +12 V are present at the connection when the vehicle reverses. Note: If it is not possible to connect to the reversing light, you must connect pin 3 to earth. This might lead to navigation inaccuracy since the TravelPilot will not be able to detect whether the vehicle is reversing. [. . . ]