User manual BLAUPUNKT TRAVEL PILOT DX-N NAV. F

[. . . ] · While you are driving, only use the voice output and directional symbols on the monitor. · Stop your vehicle at a suitable location if you wish to re-program the TravelPilot RGS 08 or look up more detailed information. Route guidance The current traffic routing situation can differ from the data stored on the CD-ROM. Due to system limitations, the TravelPilot RGS 08 cannot warn of altered traffic routing conditions e. g. If you do not pay attention to the actual traffic routing conditions, there is a danger that you will cause a serious accident. [. . . ] Depending on the function selected, you can then either use the , , and keys to move the destination marker to the next map position that you want to drive to or, by pressing the / keys, you can change the map scale (cursor must be positioned in front of +/-). After you have entered your destination and guidance has been started by pressing the ENT key, you can begin your journey. The system begins to calculate a route using the road map that is stored on the CD. The display shows a message informing you that the route is being calculated. Afterwards, an arrow appears indicating the direction in which the destination lies. The Calculating route message is displayed and the voice output indicates that: "The route is being calculated". In addition, the distance to the destination "as the crow flies" is also displayed. 15 If you are travelling in your vehicle down a digitised street, you will be guided to your destination (after the route calculation has been completed) by spoken recommendations and by the navigation symbols in the display. The voice output volume can be increased/ decreased during navigation by pressing the / keys. By pressing the ENT key during your journey, the destination information will be displayed for approx. While the destination information is being shown, you can switch to the Nav menu by pressing the ENT key again in order to, say, access the Info menu. This is the distance from the current vehicle position up to junction C. By pressing the key, you can add the subsequent route section to this selection as well. By pressing the key, the sections you selected can be removed from the exclusion list again. Once you have selected the desired length of the route section to be excluded, press the ENT key. A new route will then be calculated taking the traffic disruption into account. By pressing the Abort menu item, you can leave the traffic congestion menu without any changes having been made. If an alternative route was calculated and you press the key again, the traffic congestion menu will appear again and will offer you the additional option of deleting the alternative route. If you want to do this, position the cursor in front of Delete and press the ENT key. A new route will then be calculated and the navigation menu will appear. Note: The traffic congestion function is cancelled either when the destination has been reached, when a new destination is entered or when a new traffic jam is entered. 19 Information on the display During route guidance, two types of display can be shown on the monitor: · · navigation symbols (driving recommendation symbols) map display. Navigation symbols If the map display has been activated, you can switch to the navigation symbol display by pressing . [. . . ] After the service menu appears, close it by accessing the Navigation menu item. If Normal is selected, the route will be travelled along only once and will then stop. A new destination must then be entered and route guidance must be restarted. If Auto repeat is selected, the demo will run in a continuous loop, i. e. [. . . ]