User manual BLAUPUNKT PUEBLO CR45

[. . . ] close to fire, heating devices or in a parked car with direct exposure to the sun. · If battery liquid comes into contact with your eyes or skin, immediately flush with water and consult a doctor. · Remove the device from the power supply when you park your vehicle since it continues to use battery power and could deplete the vehicle battery. Do not unplug the connector of the power supply by pulling on the wire. [. . . ] u Touch the symbol to reach the Map Settings menu. Moving and scaling the map To view the desired destination area on the map, you can move the map section and scale it (zoom in and zoom out). Touch the button to return to your u current position. Performing map settings u Touch the symbol in the map view. The Map Settings menu is displayed. u Touching the map u Touch a location (the street or the point of interest) in the map. - or - Touch the symbol to toggle between day and night display or to activate the automatic function. If you activate the automatic function, switching between day and night display occurs automatically. In the process, the display brightness is constantly adjusted to the light conditions. (For further details, read the chapter "Settings", "Performing device settings"). u / Touch the symbol to change the map orientation between driving direction and direction North. 25 Working with the map | Voice output during route guidance u Touch the symbol to change these settings for the speed limit: Touch the symbol to show (check mark) or hide speed warnings (no check mark) on the map. Touch the symbol to switch the ­ warning beep on (check mark) or off (no check mark). Touch the symbol to adjust a tol­ erance value for the speed warning. Note: This information can be displayed only if it is activated in the navigation settings. "Working with the map", "Performing map settings") The so-called "carsor" represents your position. Top field: Name of next street Bottom field: Name of current street The action arrow shows the next action and the distance to that action. When you come closer to the location of the next action, a bar is shown on the right side: The fewer yellow segments are displayed, the closer you are to the location of the next action. 27 Additional functions during the route guidance Additional functions during the route guidance Prerequisite: · Route guidance - or · Route simulation (demo) u Touch any position on the map to display additional functions. The Route Guidance Options add-on menu is displayed. The route is recalculated and the blocked route segment is evaded. To cancel the blocking: In the add-on menu, touch the symu bol again (the check mark indicates that a blocking has been entered). - or u Touch No in order to not delete the blocking. Cancelling route guidance u Touch the symbol in the add-on menu. - or u Touch No to continue the route guidance. The following functions are now available: ­ Entering a blocking ­ Cancelling route guidance ­ Skipping the next destination ­ Display information about the destination ­ Display route list Skipping the next destination Prerequisite: · Tour with at least 1 interim destination (tour planning) In the add-on menu, touch the symu bol to skip the next interim destination. The route is recalculated and the next destination is approached. Entering a blocking During the route guidance, you can block the route segment lying ahead of you. An alternate route is calculated and the blocked partial route is bypassed. [. . . ] Touch the desired road map in the list to select it. 9 Memory cards Memory cards You can use a memory card with the device for the following: · Own POI lists · Reinstalling the navigation software and road maps (recovery) Step 1 ­ Preparing the memory card The device accepts SD/SDHC and MMC cards. Connect a commercially available card reader or the device to your computer and insert a memory card. Ensure that the memory card was formatted using the file system FAT 1 or FAT : ­ To do so, select My Computer (PC) or Finder (Mac). ­ Right-click on the removable media drive or the drive that appears and select Format > FAT (PC). [. . . ]