User manual BLAUPUNKT PARIS RCM 169

[. . . ] Instructions for installation and connection Disconnect the battery ground wire during installation and connection. When drilling a hole, be sure not to damage any vehicle part (battery, cable, fuse, etc. [. . . ] Attention: Pay attention that the cables do not contact with the housing. Connection with QuickOut installed ex factory If your car is fitted with a QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed. Insert the car radio from the front into the support and push in until the stop springs on the sides engage right and left (distinct click to be heard). Insert the brackets right and left into the provided trimplate holes and push in until you hear a distinct click (lateral springs are unlocked). Some Mercedes vehicles are equipped with a 10-pin connector located in the installation compartment. This connector must not be hooked up to car radio, since otherwise the positive supply line feeding the antenna or amplifier would be shortcircuited to ground! as a result , one of the conductive tracks in the radio would start burning. Connect the fuse holder to protect the positive cable and connect it to the positive pole of the battery (if necessary, drill a hole into the fire wall and use cable ducts). Install the car radio into the DIN cut-out provided in your car's dashboard ex factory. Prepare the car radio DIN cut-out (unlock shelf or dummy cover) or cut out the car radio compartment to 182 x 53 mm. Grasp behind the car radio cut-out and check how many of the fixing strips of the car radio support can be bent. Insert the support into the cut-out and bend the appropriate fixing strips with a screwdriver, see fig. If you have connected a car telephone, your car radio will be mutet during telephone calls. Sätt in bilradion framifrån i fästanordningen och skjut in, tills hållfjädrarna på sidorna till höger och till vänster griper in (ett tydligt knäpp hörs). [. . . ] Sätt in bilradion framifrån i fästanordningen och skjut in, tills hållfjädrarna på sidorna till höger och till vänster griper in (ett tydligt knäpp hörs). Stick in byglar till vänster och till höger i de befintliga hålen i panelen och tryck in så långt, att ett tydligt knäpp hörs (sidofjädrarna går ur ingrepp). [. . . ]