User manual BLAUPUNKT MELBOURNE C34

[. . . ] Then push the left hand side of the front panel until it is securely locked. Remove the Tape from the unit, if any, and turn off the power of the unit. Grasp Press the the front panel as shown below and remove it from the unit. â· Do not expose cassettes to direct sunlight, extremely low temperatures, or moisture. [. . . ] You can select an equalizer curve for 3 music types (Rock, Pop, Classic). Press the MENU for more than 2 seconds to enter the audio adjustment mode. Press the MENU , then press the or play the "MESG ON" on the display window. Press the SRC or PWR , then rotate the VOL dial to select the desired message you want to erase. Press the MENU , then press the or play the "MESG ON" on the display window. (See page 3 "Adjusting the Sound Characteristics") Press and hold the (USER 1) or (USER 2) for more than 2 seconds to store the equalizer curve, while displaying "BAS/TRE" in the display window. To erase /correct a message, press the MENU for more than 2 seconds to clear the character and re-enter. â· If you make no button input or dial operation in 30 seconds, the message edit mode will turn off automatically. When entering a name, pressing the following buttons affects the display of characters as follows. Press the MENU for more than 2 seconds to enter the audio adjustment mode. Unit will scan preset memory for the each 6 stations from the MW/LW band or the 18 stations from the FM bands. The unit will stop at each receivable station for 10 seconds, before continuing to the next preset station. Press the again to stop Preset Scan Tuning and remain this on the selected frequency. After 4 seconds of completing Manual Tuning, the tuning control will revert to the Seek Tuning mode. You can store up to 6 stations on each band (18 for FM, 6 for MW and LW) in the order of your choice. To resume playback, press the opposite direction button halfway to release the locked button. Press and hold the desired preset memory button 6 for about 2 seconds until the frequency indicator flashes twice. The number of the pressed preset memory button appears on the display window. The unit will scan the selected band for stations and the unit will stop at each receivable station for 10 seconds, before continuing to the next station. Press the again to stop Scan Tuning and remain this on the selected frequency. If when you store another station on the same preset number button, the previously stored station is replaced with new one. Please check with your nearest car stereo specialist for recommendations of the models that will work with this radio. [. . . ] Back of the unit Use the supplied release keys when you need to remove the unit from the car. This will unlock the unit from the sleeve, allowing for removal of the unit. If the connectors of the unit and the front panel are contaminated, malfunctions may occur. Detach the front panel and clean the connectors with an alcohol dampened cotton swab as shown below. [. . . ]