User manual BLAUPUNKT JACKSON CM148

[. . . ] Cassette ~~tQpedi~ i t!P Control cassette et c~~t~~le de chanlelrr 6 Receptor cun Cassette y Control Camhiador Radii-C~ssete corn CantrQ"le par t~~hi~d~r C Bosch Group FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] 1. 4 kg (3. 0 lb. ) 12 V DC car battery (1 l-l 6 V DC allowable) 15°F to 12O"F, -10°C to 50°C Unit Faceplate Wire Harness, including 2-Channel RCA Preamp Output Harness DIN Sleeve Mounting Hardware Owner's Manual in English, French, Spanish and Portuguese 4-Channel Preamp Output Harness (Part No. 8634494218) CDC-A05, CDCA071, CDC-A08 CD Changers, CDC-A08 adapter 7607898093 l l l l l l l l Audio Speaker Impedance: Maximum Amp Power: RMS Power: Bass Control: Treble Control: Loud: Preamp Output: Cassette Signal-to-Noise Ratio: with Dolby B Noise Reduction: Tape Wow and Flutter: Tape Frequency Response: General Dimensions (w/o projecting parts/controls): Mass: Power Requirement (neg. grnd. ): Operating Temperature: Supplied Accessories: Optional Accessories: Design and specifications subject to change without notice. 11 Location of Controls 12 3 4 5 6 78 9 10 11 f (/ CD CHhNGER ZONTRC LLER 3 fillnl0 TS SENS OISP 35 WAlTS x 4 l HIGH POWER 0 BLAUPUNKT \y --r Y-. -- JJI 22 12 13 14151617 18 19 20 21 1. A Button Seek and Manual Tuning CD Track Up Audible CD Cue Clock Hours 15. V Button Seek and Manual Tuning CD Track Down Audible CD Review Clock Minutes 16. Display Instructions - General Operation See Traffic Safety & Precautions on page 4. "Time Out" When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. 12 Ignition-Off Clock Recall Any button press while ignition off displays time for about 8 seconds. If power was not switched off before face removed, unit will automatically poweron when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting tape, in which case tape player becomes active. (If faceplate still attached, display switches to clock. ) Setting the Clock Turn the unit on. Press the CLK Button for four seconds until the clock starts blinking. Ignore this and continue to hold for two more seconds. ) Once the clock starts blinking, Press the A to set the hour, and press the V Button to set the minutes. (To change the minute indicator to the nearest hour (:OO), you can press the MUTE Button. Changing the Information Displayed The display priority choices are clock or functional information (radio freqency, "TAPE 1 or 2", and Track Number/Disc Number for changer. l 3 To change the display priority, press the CLK Button for two seconds. The display priority choices are clock or radio frequency/"TAPE"/Track No. To change the display temporarily, press and release the CLK Button to access the desired information. After four seconds, the display changes back to the priority information. l Source (SRC) Use SRC to select source - AMT, FMl, FM2, FMT Cassete (if already inserted), and/or CD Changer (if connected). Audio Operation Volume Control Buttons (+/-) Press +and - to increase/decrease volume from 0 to 63, in increments of 1. 25 dB/step. Volume control is accessible from all modes except Bass, Treble, Balance and Fade modes. Adjustable Maximum Turn-On Volume First adjust the volume to the (maximum) volume level desired when the unit is turned on. When the unit is turned on, the volume will be at the memorized level, even if the unit was turned off while the volume was at a higher level. However, if the volume is turned off when the volume level is lower than the stored Turn-On volume level, the volume will be at the lower level when the unit is turned back on. [. . . ] Track Repeat To play current track repeatedly, press RPT as needed until "rPT" appears. If track manually advanced, "rPT" remains active for new track. Disc Repeat To play current disc repeatedly, press RPT as needed until "rPTd" appears. To cancel repeat features, press RPT as needed until "PLAY" indicator appears. [. . . ]