User manual BLAUPUNKT IVMR-7001

[. . . ] To avoid causing a road accident, never use the monitor during the journey. Do not place the monitor's aerial in the following positions: 1. Do not install the aerial in locations where it could restrict the driver's rear view. [. . . ] Close the bulb cover. Bulb cover Screws Red = Electrical supply (12 V) White = Internal lighting system Black = Ground Caution: The screws have different sizes. Make sure that the screws are screwed tight to ensure a good ground connection. Light bulb Light bulb specifications Diameter: Length: Voltage: Type: 8 mm 29 mm 12 V direct current, 5W Stanley A3022C or a type with the same specifications Monitor connection Connecting cable System cable Light cable for the main unit 22 USING FOR THE FIRST TIME Select a suitable position for secure installation of the monitor: The device must not distract the driver or restrict the driver's view. The device must not be installed in such a way that could prevent the other vehicle components from functioning properly (e. g. Make sure that the device is installed in a safe and secure position and cannot become detached in the event of an emergency stop. If you need to drill additional holes, make sure you do not drill through the vehicle's sheet metal. Avoid using the monitor over a longer period of time whilst the engine is off so as to prevent the battery from becoming drained. DEUTSCH Installing the monitor 23 DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH OPERATION Operation Opening the monitor Press the monitor release button to flip down the LCD display. Closing the monitor Rotate the monitor back to its central viewing position (see the following diagram). To watch the television, lower the monitor until it is at an angle of 90 degrees to the main unit. Push the monitor back into its main unit so that the screen clips back into the releasing/locking mechanism. Switching on the monitor Repositioning the monitor The monitor can be rotated by up to 30 degrees to the right and left from its central viewing position (see the following diagram). Press the power-on button on the main unit or on the remote control to switch the monitor on/off. Note: Before the monitor is switched on, the power indicator lights up orange. This means that the monitor is connected to the 12 V direct current electrical supply. Furthermore, "NO SIGNAL" will flash on and off in the on-screen display (OSD) as long as there is no A/V input signal present. 24 OPERATION DEUTSCH Display controls Remote control AV/TV MUTE POWER MENU CHANNEL VOLUME Press this button to switch between AV and TV channels. Note: This function is only available if the E/A box is connected or the E/A box together with the tuner box. AUTO PROG (Automatic programming): Select this option on the remote control or in the OSD menu if you want the monitor to automatically search and store the television channels. The specifications are as follows: TV system Channels USA 2-69 JAPAN 1-62 PALB/G 2-69 PALD/K 1-57 PALA/I 21-69 25 Press the "OSD" button to open the OSD menu or select a function in the OSD menu. SRC: Press this button to select the AV channel (channel 1 ­ channel 5) of the AV signal converter. [. . . ] Reception position The headphones/receiver receive audio signals within certain ranges from any direction and directly. You can find out which address is closest to you by contacting the telephone hotline listed on the back page of this booklet. Blaupunkt retains the right to rectify defects or supply a replacement. APPENDIX Changing the battery in the remote control Push the battery compartment button to the right (see A below). DEUTSCH DANSK PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Appendix Pull the battery compartment out of the remote control (see B below). Change the battery. + A B Subject to changes! [. . . ]