User manual BLAUPUNKT CL 216

[. . . ] Be sure to observe the safety notes of the automobile manufacturer (airbags, alarm systems, on-board computers, immobilisers). Before drilling holes, look to see what is on the other side - making holes into the battery, wiring looms or fuse box is not recommended!During operation of the unit, the set's side wall may heat up considerably. [. . . ] In some vehicles you will find a 20-pin connector pre-fitted in the dashboard's installation space. in vehicles manufactured by Audi and VW , the 8-pin positive/negative connector provided in the car must not be connected to a Blaupunkt radio directly!Otherwise the permanent +12 V line will be short-circuited to ground, leading to serious damage of the radio's internal circuitry (burn-out of printed conductor). Reach behind the car radio compartment and check to see which tab fasteners can be bent for the mounting bracket. 6 Do not connect the control wire to terminal 15 (+12 V switched) or terminal 30 (permanent +12 V), maximum load < 100 mA. 10 Connection in vehicles with QuickOut In vehicles equipped with a QuickOut (currently Opel), the QuickOut unit must be removed and the adapter cable used. Installing the car radio Place the car radio in the front of the mounting bracket and push it in until the side springs snap into position on the left and the right (you will hear an audible click). then strip the insulation and attach a cable lug (solder if necessary). Remove the paint of the ground contact surface and treat with graphite grease (important for a good ground connection). Brown / ground When connecting the positive line to terminal 15 of the fuse box (+12 V via ignition) behind the fuse, it will be possible to turn the system on and off via the ignition. 5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 100 mA. [. . . ] The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 100 mA. Kapa minuskabeln på den fordonsspecifika Blaupunkt-adapterkabeln, förbind den med anslutningskabel 7 607 884 093 och lägg minuskabeln till ett lämpligt godsställe, exemplevis karosseriskruv, karosseriplåt, och förkorta i förhållande till godsstället (bilda inga ledningsringar). Montering av bilradion Sätt i bilradion framifrån i hållaren och skjut in den, tills hållfjädrarna på sidorna till höger och till vänster arreteras (det hörs tydligt att det knäpper till). [. . . ]