User manual BLAUPUNKT CDC-A01 CHANGER

[. . . ] 11 Installation Procedure for Installation on Carpet (Horizontal Position) . . . . . . . . . . . . . . . . . . . . . . 11 Installation Procedure for Installation on Carpet (Vertical Position) . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Installation Procedure for Installation on Carpet (at a 45° Angle) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If it is installed upside-down or with the front facing down, malfunctions may occur. 4 BEFORE INSTALLING THE EQUIPMENT ENGLISH PORTUGUÊS ESPAÑOL FRANÇAIS Position of the Built-in AntiVibration Armature This device can be installed horizontally (suspended), vertically, or at a 45° angle. Once you have chosen an installation procedure, you have to set the position of the built-in anti-vibration armature accordingly. Vibration may cause CDs to skip if the equipment is used before the antivibration system has been configured correctly. - The anti-vibration armature is set to "0" (for horizontal installation) at the factory before shipping. - The built-in anti-vibration armature adjusts on both the left and right sides. - Before attaching the brackets, use a screwdriver to set the position of the anti-vibration armature. For horizontal or suspended installation: Make certain that the built-in anti-vibration armature is set to the "0" position. 5 BEFORE INSTALLING THE EQUIPMENT For vertical installation: The built-in anti-vibration armature should be set to the "90" position. USING THE CHANGER Using the Changer Loading a CD 1. Press the button on the CD drawer of the magazine and slide out only one drawer. For installation at a 45° angle: The built-in anti-vibration armature should be set to the "45" position. 2. Insert the CD in the drawer with the playable side down (in other words, with the label facing up). Each drawer can only hold one CD. Printed side faces up Playable side faces down 3. Press the button on the CD drawer so that it closes by sliding inside the magazine. 6 USING THE CHANGER You can load up to ten CDs. ENGLISH To eject the magazine: Installing the Magazine 1. First make certain that the magazine is oriented so that the CD labels face up and so that the magazine faces in the proper direction for installation. When the magazine is used for the very first time, it will not engage until the changer is connected to electrical power. Note: Always close the cover after loading a CD or removing the magazine. That way the equipment is impervious to dust, dirt, and other foreign bodies. 7 PORTUGUÊS To eject the magazine, press the Eject button ( ). ESPAÑOL FRANÇAIS HANDLING CDS Handling CDs New CDs The following symptoms often occur when using new CDs: - The CD does not play evenly after being inserted. - The changer changes to the next CD before it has finished playing the first CD. - The system will not play a specific CD. Bur things happen, use a pen or a similar object to remove the burs as shown in the figure at right. [. . . ] Do this using the hex bolts (M6 x 12) and hex nuts (M6). 2. Position of the built-in antivibration armature Hex bolts (M6x12) 3. - Unscrew the hex nuts and remove the CD changer. Hex bolts (M4x5) 11 INSTALLATION 4. - Using a knife, cut through the carpet directly above the bolts of the mounting bracket (B). - Replace the carpet in its original position, so that the bolts poke through the carpet. Installation Procedure for Installation on Carpet (Vertical Position) 1. - Make certain that the built-in anti-vibration armature has been set to the "90" vertical installation position on both the right and left sides. - Using the hex bolts (M4 x 5), fasten the left and right brackets (A). [. . . ]