User manual BLAUPUNKT BREMEN RCM 127

[. . . ] Radio / Cassette Bremen RCM 127 Operating instructions Table of contents Traffic safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Quick reference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 First-time installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Depending on the situation, call up the main radio menu · by pressing MENU , EXIT or TU. If TA is highlighted as well, the priority is switched on. S NDR 2 FM MW LW TA PTY SVENSKA R-TEXT REGIONAL 29 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS ESPAÑOL CD - Betrieb (Option) PORTUGUÊS Switching the priority on/off: · Press TA. Interrupting a traffic message when it is being broadcast: or SRC on the remote control during the message. The recording of this message in the TIM memory will only be interrupted if the message was switched through by EON. If you press TA OFF you will switch off the priority status for traffic messages. S NDR 2 FM MW LW TA PTY R-TEXT REGIONAL S Warning beep Situation: The priority for traffic messages is activated, TA is lit up in the display. If you select a radio station which does not broadcast traffic announcements or leave the reception area of the traffic programme station you are currently tuned into, TA will disappear from the display and you will hear a warning beep approximately every 30 seconds. This beep indicates that not all of the traffic message functions are activated. Switching the warning beep off Tune into another station which broadcasts traffic information or switch off the priority for traffic announcements in the main radio menu by pressing TA. TRAFFIC MESSAGE NDR 2 TA OFF EXIT Automatic start of station search (when operating the tape or optional CD player) When you leave the reception area of the traffic programme station you are tuned into while listening to a tape or a CD, the system will automatically start searching for a new TA programme. 30 If no such station is found within approximately 30 seconds, you will hear a warning beep every 30 seconds. Switch the warning beep off as described above. Adjusting the volume for traffic announcements This volume was preset at the factory, though you can alter the value using the DSC function (see "Programming with DSC ­ TUNER, TA VOL"). Adjusting the sound stage for traffic messages and TIM You can adjust the treble, bass, balance and fader settings separately for both traffic announcements and TIM. It is, for example, possible to have only the front left (or right) speaker transmit the traffic messages. This provides the driver with the important traffic information without unnecessarily bothering the passengers in the vehicle. To alter the setting: During an announcement · press S briefly. · · Select the settings you wish to adjust by pressing the corresponding key, e. g. treble. S Press << / >> or / to adjust the sound as you wish to hear it for future traffic messages. 8 seconds after the last setting is made, the unit will switch back to the previous menu. You can return to the previous menu immediately by · pressing EXIT . TIME TREBLE BASS FADER BALANCE 12:13 EXIT 31 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS Traffic Memo (TIM) This set is equipped with a digital speech memory which can automatically record up to four traffic messages lasting a maximum of four minutes. As soon as TP appears in the display, the system will record all incoming traffic messages broadcast by the station when the radio is switched on. If the priority for traffic announcements is activated (TA shown in the display panel), the set will also record the messages broadcast by the traffic station of the same programme network (see also "Traffic message reception with RDSEON"). If "TIM ACTIVE" appears briefly in the display when the radio is switched off, the TIM standby mode is active. In this case the radio will record the traffic information broadcast for 90 minutes before and after the programmed TIM times even if it is switched off. The radio will also record the traffic messages broadcast by the last station it was tuned into for three hours after the set has been switched off. Depending on the length of the new message, the oldest messages will be deleted automatically. [. . . ] LEVEL 0: Music/speech off DSC-TUNER MENU S-LO TIM TIME TA VOL S-DX TABLE PTY-LANG SPEECH EXIT ST NAME PTY-LANG SPEECH 61 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS LEVEL 1: Linear reproduction (bass, treble and Loudness set to "0"). LEVEL 2-4: Different settings for volume, bass and treble with the Loudness switched off. Set the station search sensitivity for local radio stations LO 1 - high sensitivity LO 3 - normal sensitivity Set the station search sensitivity for distant radio stations DX 1 - high sensitivity DX 3 - normal sensitivity Set the size of the station table, depending on the sensitivity TABLE SIZE 1 longest station table (all stations within reception range) TABLE SIZE 3 shortest station table (stations with strong reception signals only) S-LO S-DX TABLE 62 CD CLEAR Appears only when the DSC MAIN MENU is called up while the changer is in operation. It is possible to delete both the name and the TPM title of a CD at the same time. [. . . ]