User manual BLAUPUNKT AUTOFUN -

[. . . ] To ensure no interference is caused, antenna cables must be laid at a sufficient distance from cable harnesses. The battery's negative terminal must remain disconnected whilst you are installing and connecting the device. [. . . ] After you remove the protective foil from the carrier paper of the two reception elements and from the mounting base, make sure that you do not touch the adhesive surfaces or else the adhesive strength will diminish!You must make absolutely sure that the inside surface of the screen where the antenna will be installed is completely dry!The amount of space available (see point 3) The earth connection (see point 7) How the antenna cable will be laid (see point 6) Attach the special mounting tool to the base and hold it in positions A and B to try out the different installation positions. Peel off the protective paper from the mounting base, then align the base in the correct position and press it onto the windscreen. Carefully detach the mounting tool from the base and rub the base onto the windscreen using the wiper. Attach the adhesive spacer strips 1 to the windscreen so that they are positioned right up against the edge of the windscreen. Place the hole end of the reception element 3 over the peg protruding from the mounting base whilst making sure that the adhesive side of the reception element is facing the windscreen. Continue applying the carrier paper along the windscreen in such a way that the outer edge of the carrier paper is positioned up against the ends of the spacer strips 1. Use the wiper to rub the reception element firmly against the windscreen. Place the transparent end patches onto the tip of the wiper and apply them to the beginning and end, and rub them down so they stick securely. [. . . ] This connection is protected by a fuse and the antenna is activated when the car radio is switch on. Anslut matarströmledningen till ett strömuttag med + 12 V, lämpligen till bilradions autom. [. . . ]