User manual BLAUPUNKT ASPEN CM147

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] When in FM radio mode, press of FM advances to next FM band, FM1, FM2, or FM3/FMT. When in AM mode or other source, pressing FM button returns to last-tuned FM band. Tuning stops at frequency that fulfills sensitivity requirements predetermined by sensitivity set through SENS/LD button. Press of /\ or V buttons for more than 1/2 second seeks next receivable frequency after button is released. Tuning Sensitivity (SENS) Press SENS/LD for more that 2 seconds to switch between LO (Local) and DX (Distant) search sensitivity Radio Reception Hints · When listening to weak or distant AM stations, adjusting the Treble to minimum (-7) will reduce noise and improve sound. · In general, set SENS to DX if in rural areas or where stations tend to be weak and distant, and to LO when in metropolitan areas or where stations tend to be strong and local. Stereo Symbol Stereo symbol turns on if a stereo station with an incoming signal of 20 dBµV is received. Manual Tuning Press << or >> and frequency will go one channel/step in direction pressed. Preset Station Storage After tuning desired frequency on desired band, press and hold a Preset Button for more than 2 seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. Travel Store This feature allows you to automatically store stations onto all 6 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press FM Button for 2 seconds to activate FM Travel Store. (In AM Bank, press AM Button for 2 seconds to activate AM Travel Store. ) T STORE appears, followed by seek-type display of frequency and preset numbers. Beginning at the bottom of the band, TS stores six strongest stations, one on each of the six preset buttons, in decreasing order of signal strength, and returns to preset 1. When source is changed during Travel Store, operation completes itself, despite source change. "STA SCAN" appears, then frequency blinks (along with preset number if appropriate) during scanning. Unit continuously scans until user stops scan by pressing SCA, another tuning button, SRC, or MENU button. "PS SCAN" appears, then frequency and preset number blink during scanning. Unit starts at FM1/Preset 1 (or AM/Preset 1) and proceeds through all presets (in FM all three banks) and returns to frequency tuned prior to PS activation and stops. Stops earlier if user presses another tuning button, SCA, SRC, or MENU button. Unit skips past preset frequencies that do not meet minimal seek-tuning threshold. Tuner Timer and Station Naming (See pages 20 and 21) 15 Cassette Tape Player Operation Once playback location change is complete, tape display sequence follows. [. . . ] Erasing ONE Radio Station Name Access Station Access mode (See Radio Station Naming, above. ) Choose station with name to be deleted. Erasing ALL Radio Station Names Access Station Access mode under Menu. "ALLNAMES" appears for 2 seconds, then "DELETED" until deletion completed. Disc Naming ("DISCNAME") Assigning a name to a disc makes it much easier to locate the desired disc. [. . . ]