User manual BLAUPUNKT ACD 2800

[. . . ] Use your car radio in such a manner that you are always able to cope with and react to the prevailing traffic situation at any given time. Remember, even at 50 km/h you are still moving at a speed of 14 m per seconds. It is also very important that you are able to hear, and react to, acoustic warning signals around you, for example from the police or the firebrigade. Therefore, adjust the volume reasonably. FRANÇAIS PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO Anti-theft coding . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · press knob (a), take the handle (b) and pull the unit out. 13 ENGLISH DEUTSCH Contents Important information Anti-theft coding To listen to the radio or cassette again, · insert the set into the compartment until it stops and move the handle back to the front panel. If the coding system is on, proceed as described under "Restart following interruption of power supply". If the anti-theft coding system is on while the power supply to the unit is interrupted (e. g. theft, disconnecting the car battery), the set is electronically blocked. Then it may only be used again after the appropriate code number has been entered (see car radio passport). If the power supply to the radio is interrupted while the code system is switched on, you need to know the right code number. The radio will operate again as soon as you have entered the right code number. If you lose your radio passport and have forgotten your code number, you will not be able to restart the set after the power supply has been interrupted. In this case, your radio can only be reset in our central customer service workshop or in one of our service agencies abroad. Installation/connection The code system can only be switched on and off, if the radio is connected to permanent power. If you like to install your new car radio by yourself or add other audio components to the existing ones, then please read carefully the enclosed instructions on installation and connection. Only use the accessory and replacement parts approved by Blaupunkt. Wrong code number entered It should not be possible for thieves to ascertain the code number by trial-and-error. Press rocker switch < > 7 on the left or right to adjust the sound impression according to your personal preferences. Note: If the rocker switch < > is kept depressed (on the left or right), the set quickly advances to the final values (+7/+9 or -7/-9) or to the "0" position. Selecting the Desired Waveband With this set you have free choice from the following wavebands: FM (ultra-short wave; frequency-modulated), MW (medium wave), and LW (long wave). Either "MW" (for medium wave frequencies) or "LW" (for long wave frequencies) lights up on display 9 g, c. For changing between MW and LW: · Press the M·L button 4 once again. If the < > rocker switch 7 is kept depressed on the right or the left, the station seek operation continues to be carried out quickly in the corresponding direction. Manual Tuning To manually tune in a station, · press the lo·m button 5 until "m" lights up on display 9 f. You can now manually search for the desired stations via the < > buttons 7. Adjusting the Station Seek Sensitivity With this set you can modify the automatic station seek sensitivity in all wavebands. If you want to search for strong stations only (reduced sensitivity): · Press the lo button 5 until "lo" lights up on display 9 e. If you also want to search for weaker stations (increased sensitivity): · Press the lo button 5 once again; the "lo" indication on display 9 e goes out. Tuning in a Station Automatically Tuning in the following station · Press the < > rocker switch 7 on the right. Tuning in the previous station · Press the < > rocker switch 7 on the left. The car stereo automatically starts searching for the previous station. 16 Mono/Stereo Operation If the lo·m button 5 is pressed longer than 2 secs. but less than 8 secs. , the set switches over to mono and the stereo symbol (h) goes off. but less than 8 secs. , the set switches over to stereo and das Stereo-Symbol (h) erscheint wieder im Display. [. . . ] The set searches for the strongest FM stations and memorizes them on the "T" storage level (Travelstore). Once the process is finished, the car radio automatically tunes in to the strongest station. If required, it is also possible to manually store a station on the Travelstore level. If less than 5 stations can be received, the free buttons are briefly represented by dashes. Inserting the Disk With this set you can play the normal standard CDs without having to use an adapter: · Switch the set on. [. . . ]