User manual BLACK & DECKER KW1600E

[. . . ] The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. [. . . ] To reduce the risk of injury, the user must read the instruction manual. Always check that the power supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. On/off switch Lock-off button Handle Variable speed control knob Plunge lock lever Spindle lock button Collet Revolver depth stop Depth stop bar Chip deflector Dust extraction adaptor Fit the distance piece (14) to the base of the router using the screws provided. Fit the centring pin (15) to the workpiece side of the edge guide with the screw (25) provided. Fit the `L' bar (16) to the upper side of the edge guide using the two screws and nuts provided. Before assembly, make sure that the tool is switched off and unplugged. Remove the chip deflector (10) by pulling it straight up from the router base. Keep the spindle lock button (6) depressed and rotate the spindle until the spindle lock fully engages. Make sure that the shank protrudes at least 3 mm from the collet as shown. Keep the spindle lock button (6) depressed and tighten the collet nut (17) using the spanner provided. The additional guide (21) is designed to allow routing of a thin piece of wood (e. Fit the edge guide (21) to the bars (19) protruding from the router base. Adjust the edge guide so the workpiece becomes clamped between the two edge guide. The depth of cut is the distance X between the depth stop bar (9) and the depth stop (29). Move the depth stop bar (9) down against the depth stop using the depth stop adjuster (31). reset the scale by aligning the zero marking (32) with the arrow (33). Move the depth stop bar (9) to the calculated position using the depth stop adjuster (31). Fit the template guide (13) to the base of the router, with the flange to the bottom (workpiece) side. Insert the two long screws (24) from the bottom side through the template guide and the holes in the base. Pull the plunge lock lever (5) up and return the router to its original position. After switching the router on, plunge it down and make the desired cut. [. . . ] Uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www. KW1600E TYPE1 Black & Decker declares that these products conform to: 98/37/EC, EN 60745 Level of sound pressure according to EN 60745: Sound pressure (LpA) 90 dB(A), uncertainty (K) 3 dB(A) Acoustic power (LWA) 101 dB(A), uncertainty (K) 3 dB(A) Vibration total values (triax vector sum) according to EN 60745: Vibration emission value (ah) 2. The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker. [. . . ]