User manual BLACK & DECKER BBC2CB

[. . . ] The use of any accessory or attachment not recommended for use with this appliance could be hazardous. Note: Refer to the accessory section of this manual for further details. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. [. . . ] WARNING: BURST HAZARD: Do not use the unit for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage property. It is not intended to supply power to a low-voltage electrical system other than in a starter-motor application. cAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: · Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or otherwise damaged in any way. Do not disassemble the unit; take it to a qualified service technician when service or repair is required. ⷠNEVER submerge this unit in water; do not expose it to rain, snow or use when wet. ⷠMake sure cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress. ⷠDo not leave the unit unattended while attempting to boost a vehicle. Before boosting, read the vehicle's owner's manual to confirm that external-starting assistance is suitable. ⷠDo not use any accessory that is not recommended or provided by the manufacturer. ⷠThis system is designed to be used only on vehicles with a 12 volt DC battery system. If the engine fails to start after the recommended number of attempts, discontinue boosting procedures and contact a qualified technician to investigate why the engine did not start. Follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use with this unit. This car to car booster is an innovative product that replaces the use of inconvenient booster cables to jump-start a car. All you need to do is to insert one end of the cable to the cigarette lighter socket of a working car, and the other end to the car that needs to be boosted. Vehicle-to-vehicle boosting without the trouble of traditional cables Compact and convenient LED status indicators Built-in Storage Cylinder Insert the Black 12 Volt DC Accessory Plug into the 12 volt DC accessory outlet of the working car. Note: Some vehicles require that the ignition key be turned to the Accessory position to activate the 12 volt DC accessory outlet; if the Power LED doesn't come on, turn the ignition key to the Accessory position or check for proper contact of the plug. Note: Place the working vehicle in "park" and set the emergency brake. [. . . ] ⷠDo not leave the unit's 12 Volt DC Accessory Plugs connected for more than 40 minutes at a time. Before boosting this type of vehicle, read the vehicle manual to confirm that external-starting assistance is advised. ⷠExcessive engine cranking can damage the vehicle`s starter motor. [. . . ]