User manual BISSELL ILLUMICLEAN

[. . . ] Do not pick up flammable or combustible materials (lighter fluid, petrol, kerosene, etc. ) or use in the presence of explosive liquids or vapour. Do not use appliance in an enclosed space filled with vapours given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapours. Not intended for use by persons (including children) with reduced sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Young children should be supervised to ensure that they do not play with the appliance. by the manufacturer or its service agent in order to avoid a hazard. [. . . ] To store with the floor nozzle attached, insert the storage clip (located on the back of the floor nozzle) into the storage slot on the rear of the vacuum. To store without the floor nozzle attached, insert the storage clip (located on the bottom of the telescoping extension wand) into the storage slot on the rear of the vacuum. To store with the floor nozzle attached, stand the vacuum in the upright position and insert the storage clip (located on the back of the floor nozzle) into the storage slot on the bottom of the vacuum. To store without the floor nozzle attached, stand the vacuum in the upright position and insert the storage clip (located on the bottom of the telescoping extension wand) into the storage slot on the bottom of the vacuum. a1. Storing in the in-use position a2. b1. Storing in the upright position b2. 6 www. bissell. com Operations Power cord the power cord is located at the rear of the vacuum. Do not pull the power cord out beyond the red line. Automatic cord rewind your vacuum is equipped with an automatic cord rewind. When cleaning is finished, press the power button off and grasp the plug to disconnect from the electrical outlet. Hold the plug and press the automatic cord rewind button to rewind the cord automatically. Automatic Cord Rewind Button Power button turn the power on or off by pressing lightly downward on the power button ( ). caUtIon: be careful to avoid injury as cord retracts very quickly. caUtIon: before using your vacuum, make sure that the dust bag and all filters (pre-motor and post-motor) are in place. Do not operate your vacuum without the dust bag and filters. Power Button www. bissell. com 7 Operations Special tools your bISSEll Illumiclean is not only a powerful carpet and rug vacuum cleaner, it's Before cleaning under also a versatile bare floor vacuum cleaner and low furniture, check area first for objects above floor vacuum cleaner when you select that might harm the one of the special tools. To vacuum carpets and rugs, push the brush switch to the carpet position . To vacuum bare floors, push the brush switch to the bare floor position . This will extend the brushes down from the floor nozzle. Tip: Brush Up Brush Down 2. 2. Dusting brush: Use the dusting brush to dust furniture, blinds, books, lamps, shelves and baseboards. Upholstery tool: Use the upholstery tool to clean curtains, draperies, cushions and fabrics. notE: Use the air flow regulator to reduce air flow as needed when using the upholstery tool. crevice tool: Use the crevice tool in tight, narrow spaces. Tip: Hair, string and small objects can block the hose and tools. Check them occasionally for obstructions. 8 www. bissell. com Operations Variable suction power control the variable suction power control is located on the top of the vacuum. Slide the control toward the smaller dots to minimize suction for lightly soiled areas or delicate fabrics. Air flow regulator open the air flow regulator by sliding the regulator back towards the handle to an open position to reduce suction for delicate fabrics. close the air flow regulator by sliding the regulator down to the closed position for full suction. High filtration dust bag the bISSEll Illumiclean features a non-woven, high filtration dust bag that captures more fine dust than traditional paper dust bags, giving off less dust emissions. It also holds more fine dust particles, giving you longer lasting suction power. Bag change indicator the bag change indicator is located between the power button and the automatic cord rewind button. If the bag change indicator turns orange while you are vacuuming, the dust bag needs to be replaced. [. . . ] to reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. 4. 4. 5. 6. 7. WaRnInG: 10 www. bissell. com Maintenance and care Cleaning the pre-motor filter the pre-motor filter protects the motor from dirt and dust particles. 1. Open the dust bag compartment by lifting up on the latch on the door at the front of the vacuum. [. . . ]