User manual BISSELL 1719

[. . . ] Do not pick up hot, burning or smoking objects such as cigarettes, matches or hot ashes. Do not pick up flammable or combustible materials (lighter fluid, petrol, kerosene, etc. ) or use in the presence of explosive liquids or vapours. Do not use appliance in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapours. Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, petrol, etc. ) Do not allow to be used as a toy. [. . . ] This procedure may be required more than once. 1. Filling the solution/clean tank 1. 2. Remove solution/clean tank by grasping it firmly and pulling straight up. Add water and formula* to the indicated fill lines on the solution/ clean tank 2. Water Fill Line WATER FORMULA *note: your Spot Lifter 2X includes two trial size bottles of formula. Formula Fill Line 3. Replace cap and place solution/clean tank back on unit. 3. 6 6 www. bissell. com Operations (continued) Pre-treating 1. To pre-treat stained or highly soiled areas, hold Spot Lifter 2X above soiled surface and press spray trigger to spray cleaning solution. Hold Spot Lifter 2X above soiled surface and press trigger to spray cleaning solution, as in pre-treating step 2 above. Press front of Spot Lifter 2X firmly against surface and pull toward you to remove cleaning solution and soil. Repeat steps 2 and 3 until no more dirt or cleaning solution can be removed. For stubborn spots and soil, use brush to gently scrub soiled area while continuing to spray cleaning solution. To remove brush from unit, gently pull on brush tab and lift out. Tip: Immediate attention to a spill on upholstery can prevent permanent staining. 3. 5. nOTe: If Spot Lifter 2X stops spraying, turn power switch "O" (OFF) and check cleaning solution level. never run dry. Tip: Use the brush after applying cleaning solution and remove any surface soil. Using the brush before applying solution can push soil more deeply into carpet. Spot cleaning upholstery 1. Check manufacturer's tag before cleaning. "W" or "WS" on the tag means you can use your Spot Lifter 2X. If tag is coded with an "S" (with diagonal strike-through), or says "Dry Clean Only, " do not proceed. If manufacturer's tag is missing or not coded, check with your furniture dealer. 2. h bv g kvh gh bj j gh dd kll df kn hn hl jf Ads j j jh bb cv ghhj gc nOTe: If possible, check upholstery stuffing. Coloured stuffing may bleed through fabric when wet. Manufacturer's Tag www. bissell. com 7 Operations (continued) Cleaning spills from hard surfaces 1. Press front of Spot Lifter 2X firmly against hard surface to suction up spill. Press front of Spot Lifter 2X firmly against hard surface to suction cleaning solution, as in step 2 above. 2. nOTe: If the Spot Lifter 2X stops spraying, turn power switch "O" (OFF) and check cleaning solution level. Carry the Spot Lifter 2X to the sink or drain. To empty the collection tank 1. 5. Remove the collection/dirty tank by pressing the tank release button at the top of the tank. [. . . ] This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, or use not in accordance with the User's Guide is not covered. For UK inquiries: Monday - Thursday 9 am -- 5 pm Friday 9 am -- 4 pm BISSeLL Homecare (Overseas) Inc. The Boat Yard 105 Straight Road Old Windsor Berkshire, SL4 2SE United Kingdom Telephone: 0844-888-6644 For new Zealand inquiries: Monday - Friday 9 am -- 5 pm Parex appliances 5 Tolich Place Henderson 0610 Auckland New Zealand Telephone: 0800-247-735 For australian inquiries: Monday - Friday 9 am -- 5 pm BISSeLL australia Pty Ltd 42 Rocco Drive Scoresby 3179 Victoria Australia Telephone: 1-800-811-183 For all other inquiries: Monday - Friday 8 am -- 4 pm BISSeLL Homecare, Inc. PO Box 1888 Grand Rapids, MI 49501 USA Telephone: 01-616-453-4451 Fax: 01-616-453-1383 BISSeLL HOMeCaRe InC. [. . . ]