User manual BIFINETT KH 527 BLENDER

[. . . ] NEVER insert your hand or fingers in the mixing jug, especially when it is in use. Should you do so, pieces of the foodstuff could be thrown out at high speeds! ⷠDo not insert cutlery items or mixing tools into the mixing jug when the appliance is in use. There is a considerable risk of injury should these make contact with the swiftly rotating cutters! [. . . ] ­ the appliance stands firmly and without risk of slipping or tipping when under vibration. ­ that the power cable y is not in the working area and thus not presenting a risk of being inadvertently snagged and tipping the appliance over. Being supplied are: 1 x Motor block, with power cable and plug 1 x Mixer jug, with permanently assembled cutters 1 x Lid 1 x Filling cap 1 x Operating instruction The motor switches itself off as soon as the mixing jug e is removed from the motor block u. The motor will thus start of its own accord as soon as the mixing jug e is replaced on it: Therefore: · First insert the power plug into the wall socket when the mixer jug e is filled and mounted with its lid fitted and closed. ⷠBefore mounting the mixing jug always check to see that the appliance is switched off or that the power plug has been removed. ⷠBefore removing the mixer jug e, switch the appliance off, remove the power plug and wait for the motor to stop revolving. Selecting operating speeds When the mixer jug e is filled, completely sealed and securely fitted to the motor block u, you can ­ Level 1-3 for fluid or soft foodstuffs, for mixing, blending and stirring ­ Level 3-5 for firmer foodstuffs or for hacking ­ Level Ice Crush/Clean for a short, powerful impulse operation, e. To avoid overburdening the motor the switch t does not lock into this position. Filling when in use Filling and mounting the mixer jug Only fill the mixer jug e when it is removed from the motor unit. Should you wish to insert further foodstuffs during operation, you may ONLY open the filling cap q provided for this purpose. ⷠDo not insert cutlery items or mixing tools into the mixing jug e when the appliance is in use. There is a considerable risk of injury should these make contact with the swiftly rotating cutters r!Afterwards, replace the filling cap q into the lid and secure it by turning it clockwise. Insert the filling cap q into the lid opening and secure it by turning it clockwise. When the processing of the foodstuffs is complete: Always first place the switch t into the OFF position ("0") and remove the power plug. Wait until the motor has come to a complete standstill before lifting the mixer jug e straight up. Before starting to clean the liquidiser and its components: · Ensure that the motor is switched off and the power plug removed from the socket. Under no circumstance may the motor block u be submersed in water or other fluids. This could result in you receiving a fatal electric shock and the appliance could be damaged. ⷠNever disassemble the cutters r and never reach into the mixer jug e. Do not use solvents or abrasive cleaners on the plastic surfaces, they could be damaged by them. ­ The best results when blending firm ingredients are achieved by placing small portions one after the other into the mixer jug e instead of inserting a single large portion. [. . . ] Remove the mixer jug e from the motor block If you do not intend to use the liquidiser for an Extended period, clean it thoroughly (see chapter "Cleaning"). Wrap the power cable y around the cable storage i on the base of the motor block u. Dispose of the appliance through an approved disposal centre or at your community waste facility. The warranty for this appliance is for 3 years from the date of purchase. [. . . ]