User manual BIAMP VOCIA MESSAGE SERVER

[. . . ] All MS-1 units must have a unique Device ID to function properly within a Vocia Paging World (i. e. , it is not possible to have two MS-1 units with the same Device ID of hex 07). To assign a Device ID of hex 07, turn the LSB switch to 7 and leave the MSB switch on 0. [. . . ] Equipment should be connected to a mains socket outlet with a protective earthing connection. This plug is the main disconnecting device and should remain readily operable. Please contact Biamp Technical Support or your local distributor for all service requirements. Settings for connection are as follows: Baud rate 57600, Data bits 8, Parity None, Stop bits 1, and Flow Control Hardware. WARNING: Replacing the Lithium Battery Incorrect replacement of the lithium battery may lead to a risk of explosion. The lithium battery must be replaced with an identical battery or a battery type recommended by the manufacturer. They must be disposed of in accordance with local regulations concerning special waste. 6 MS-1 inStallatiOn Installation The MS-1 requires one 1. 75 inch (44. 45 mm) high and 19 inch (483mm) wide rack space with 17 inch (432 mm) depth. Mounting the unit using four screws with washers will prevent marring of the front panel. When installing the rack ears, please note that the hardware is not symmetrical. Please install the rack ear labeled "left" on the left side of the MS-1 (when looking at the equipment facing the front plate) and the rack ear labeled "right" to the right of the unit. · First, remove the screw from the MS-1 chassis (with a Phillips P2 screw driver) · Attach the appropriate rack ear and re-affix the Phillips screw to the chassis and 4 additional Philips screws supplied with the rack ears. Please install the unit away from heat sources, such as vents and radiators, and in rooms with adequate ventilation. [. . . ] BIAMP Systems disclaims all other warranties, expressed or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. [. . . ]