User manual BIAMP SPM412E IR

[. . . ] SPM412e Stereo Preamp/Mixer IR Control Manual Biamp Systems | 9300 S. W. [. . . ] The controller must have the correct driver loaded, which should be configured to output a carrier stripped IR signal, and are available from the AMX and Crestron web-sites. SPM 412e Control Two versions of SPM412e have been made with a slight difference in remote connector configuration, as follows: 4 pin connector, no switch (older version) The connection from the touch panel controller and the SPM412e should be made to the ground and xlate (translate) pins of the 4 way remote connector. 3 pin connector with switch (newer version) The connection from the touch panel controller and the SPM412e should be made to the ground and idle high pins of the 3 way remote connector, with the switch pressed in to allow a translate input. The functions that can be controlled and the related Biamp button numbers are shown below: Basic Commands* This command set will allow the control system to perform the basic front panel controls of the SPM412e. Biamp Button number 4 8 12 25 26 27 28 AMX* Button number 46 50 54 67 68 69 70 Function Volume down Volume up Mute toggle Selects stereo input 1 Selects stereo input 2 Selects stereo input 3 Selects stereo input 4 * Using the file biamp000. irl from the Panja (AMX) control disc Advanced Commands * This command set will allow the control system to perform the basic front panel functions, as well as more advanced controls like setting the master volume to a percentage or enabling a combination of inputs to be selected at the same time. These Advanced Commands will only work with a SPM412e, and are not supported by the older SPM412 mixer. Biamp Button number 4 8 12 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 AMX* Button number 4 8 12 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 Function Using BIAMP001. irl Volume down Volume up Mute toggle Selects stereo input 1 Selects stereo input 2 Selects stereo input 3 Selects stereo input 4 Selects no stereo input mutes the main Output un-mutes the main Output sets main level to 4% sets main level to 16% sets main level to 28% sets main level to 40% sets main level to 52% sets main level to 64% sets main level to 76% sets main level to 88% sets main level to 100% Using BIAMP002. irl Select No Stereo Input Select Ch. 1 Select Ch. 2 Select Ch. 1 & 2 Select Ch. 3 Select Ch. 1 & 3 Select Ch. 2 & 3 Select Ch. [. . . ] Biamp button numbers 214-256 are used on the Panja (AMX) IRLib file BIAMP002. irl. [. . . ]