User manual BIAMP NE-TWORKED PAGING STATION-1

[. . . ] Scroll Wheel: This rotary encoder allows navigation through the available menus and selections during setup and normal operation. : This physical button initiates the selected page routing scheme(s) during normal operation. During setup, the Push-To-Talk behavior of this button may be assigned as either momentary (push-on/release-off) or latching (push-on/push-off). [. . . ] These settings may instead be assigned via software Device Maintenance. Use the Scroll Wheel and Enter button to select the desired characters. During normal operation, holding the Cancel button for 2 seconds will lock the unit, and the user will be prompted for the Lock Code before being given access. To change the contrast of the LCD Panel, scroll to the Contrast icon and press Enter. Use the Cancel button to exit from a selection or screen. Setup screen - ID Tag icon Edit Station ID screen Setup screen - Network icon Edit Net Config screen Setup screen - Key icon Edit Lock Code screen Setup screen - Contrast icon Edit LCD Contrast screen To change the behavior of the Push-To-Talk button, scroll to the Page Button icon and press Enter. The left icon (single arrow) indicates latching (push-on/pushoff) behavior. The right icon (double arrows) indicates momentary (push-on/release-off) behavior. To assign or change a maximum paging duration, scroll to the Timeout icon and press Enter. Page Timeout will automatically end prolonged paging, regardless of whether it is due to latching or continued momentary behavior of the Push-To-Talk button. Setup screen - Page Button icon Edit Page Button Mode screen Setup screen - Timeout icon Edit Page Timeout screen 4 Networked Paging Station-1 - Setup To change the microphone input gain, scroll to the Mic icon and press Enter. Increased gain helps compensate for soft or distant talkers, but may result in amplified background noise and/or distortion of louder signals. To view information regarding the specific unit, scroll to the Information icon and press Enter. Displayed are the Serial Number, MAC Address, Firmware Version, and System ID. The Serial Number is helpful in identifying physical units/locations, when naming them via software Device Maintenance. Setup screen - Information icon Unit Information screen During normal paging operation (when connected to a programmed AudiaFLEX system), page routing schemes are selected as 'soft-buttons'. [. . . ] Such evidence may consist of your sales receipt from an authorized BIAMP Systems dealer. Transportation and insurance charges to and from the BIAMP Systems factory for warranty service shall be your responsibility. This warranty will be VOID if the serial number has been removed or defaced; or if the product has been altered, subjected to damage, abuse or rental usage, repaired by any person not authorized by BIAMP Systems to make repairs; or installed in any manner that does not comply with BIAMP Systems' recommendations. [. . . ]