User manual BIAMP DJ 4000

[. . . ] NOTE ­ To avoid fault conditions, High Pass Filters (HPF) must be assigned on those channels having transformers installed. RECOMMENDED TOOLS: · · · Phillips screwdriver Adjustable wrench Pliers TDT50 & TDT150 INSTALLATION INSTRUCTIONS 1. Remove the amplifier top panel by removing 17 screws (6 on each side, 3 on back and 2 on front). [. . . ] Remove the amplifier top panel by removing 17 screws (6 on each side, 3 on back and 2 on front). Each amplifier card represents two individual output channels; one odd and one even (refer to figure 2 for reference). Using a pair of pliers, remove the black and red jumper from the associated amplifier channel. Following the diagram below (figure 3), connect the wires as indicated. Please note that wires on odd channel are mirrored from wires on even channel. FIGURE 2 Brown wire = 25V Blue wire Orange wire = 70V Yellow wire = 100V Blue wire Brown wire = 25V Orange wire = 70V Yellow wire = 100V Amplifier Cards FIGURE 1 Odd channel jumpers (Ch 1) Even channel jumpers (Ch2) Nut Metal Dome Washer Rubber Washer Transformer Rubber Washer Transformer Rubber Washer Bolt Odd Channels (1, 3, 5, & 7) Even Channels (2, 4, 6, & 8) Black wire FIGURE 3 Green wire Green wire Black wire 8. (figure 10) FIGURE 9 High Pass Filter (HPF) dip switches Affix transformer stickers FIGURE 10 DoC MCA201003 EC Declaration of Conformity Biamp Systems Corporation, as manufacturer having sole responsibility, hereby declares that the following described product complies with the applicable provisions of the DIRECTIVES below except as noted herein. Any alterations to the product not agreed upon and directed by Biamp Systems Corporation will invalidate this declaration. Product Models: MCA 8050 with optional Output Transformers TDT50 or TDT100 MCA 8150 with optional Output Transformers TDT150 or TDT300 Product Description: Audio Amplifiers and Distribution Transformers Applicable EC Directives: LVD Directive (2006/95/EC) EMC Directive (2004/108/EC) Applicable Harmonized Standards: Safety Emissions Immunity EN 60065:2002 EN 55103-1:1996, Environment E2 EN 55103-2:1996 Special Considerations for Product Environment or Compliance: Shielded cabling must be used for system connections. Technical Documentation File, Location and Contact: Biamp Systems, Inc. Gemini Drive Beaverton, OR USA 97008 Authorized Representative: Authorized Signature: Issued: March, 2010 phone: fax: e-mail: (503) 641. 7287 (503) 626. 0281 biamp@biamp. com Larry Copley, Compliance Engineer Biamp Systems | 9300 S. W. [. . . ] Product Models: MCA 8050 with optional Output Transformers TDT50 or TDT100 MCA 8150 with optional Output Transformers TDT150 or TDT300 Product Description: Audio Amplifiers and Distribution Transformers Applicable EC Directives: LVD Directive (2006/95/EC) EMC Directive (2004/108/EC) Applicable Harmonized Standards: Safety Emissions Immunity EN 60065:2002 EN 55103-1:1996, Environment E2 EN 55103-2:1996 Special Considerations for Product Environment or Compliance: Shielded cabling must be used for system connections. Technical Documentation File, Location and Contact: Biamp Systems, Inc. [. . . ]