User manual BIAMP COBRANET

[. . . ] Go to the Cirrus Logic download site located in the following link: http://www. cirrus. com/cobranetsoftware Download CobraNet Discovery Utility (Disco) to your desktop (CNDisco344. exe) Double click on CNDisco344. exe to install the utility. [. . . ] 12. Connect the Ethernet port on your computer to the same network switch as the CobraNet devices on your network. You can also connect directly to the CobraNet port on the Audia unit with a cross-over cat5 cable. Open CobraNet Disco by going to Start > All Programs > CobraNet Discovery > CobraNet Discovery Open the options menu by going to Tools > Options Make certain your network card is selected under "Network Adapter" and click on "Enable Auto Assignment" to select it. Click "OK" BIAMP SYSTEMS TECHNICAL SUPPORT GROUP www. biamp. com · Page 1 of 2 Figure 2 ­ CobraNet Disco settings 13. 17. All units connected to the CobraNet network should appear in the CobraNet Disco window. Each line shows each individual unit, an IP address, MAC address and current firmware version. [. . . ] Power cycle the unit when prompted to do so and click "OK" After the system boots up, go to View > Refresh to verify that the firmware was installed. If this application note did not answer your questions on the topic of "CobraNet Firmware Update Procedure", please contact Biamp Technical Support Group by phone at + 1 800 426 1457 or by email at support@biamp. com. BIAMP SYSTEMS TECHNICAL SUPPORT GROUP www. biamp. com · Page 2 of 2 [. . . ]