User manual BIAMP AUTOTWO

[. . . ] NOTE: Accurate Trim control settings are essential prior to Threshold adjustment (see Threshold below). Once Threshold has been set, individual channel sensitivities may be fine-tuned using the Trim controls. If input signals exceed normal operating range of the Trim controls, assign the Pad switch (see DIP switches on next page). Level (Channels 1~8): These controls adjust the amount of signal sent from the individual input channels to the mixer output section. [. . . ] This information allows the mixers to properly perform NOM Attenuation & Adaptive Threshold Sensing. The information shared is processed primarily by the `master' autoTWO. To prevent system errors, the second autoTWO mixer should be assigned as `slave' (see Master DIP Switches below). Channel 1 override can be achieved by shorting pins 3 & 6 (see Logic Outputs on pg. Main Output: These plug-in barrier strip terminals provide the balanced line-level Main Output from the mixer. For unbalanced connection, wire high (+) and ground ( ), leaving (-) unconnected. Main Output level is affected by the front panel Master control, as well as by automatic NOM Attenuation, which reduces the output level by 3dB for each doubling of active (gated) channels. Aux Output: These plug-in barrier strip terminals provide the balanced line-level Aux Output from the mixer. For unbalanced connection, wire high (+) and ground ( ), leaving (-) unconnected. Aux Output level is affected by the front panel Aux control, but not by automatic NOM Attenuation. Stack In: These plug-in barrier strip terminals provide a balanced line-level Stack In to the mixer. Signal entering here is combined with signals from the input channels, and is then sent to the Main Output section. When using multiple autoTWO mixers within a system, connect Main Output of one mixer to Stack In of the next mixer, and so forth. All mixers except the final autoTWO should be assigned as `slaves' (see Master DIP Switches below). For unbalanced connection, wire high (+) and ground to both ( ) & (-). Inputs & Direct Outputs (Channels 1~8): These plug-in barrier strip terminals provide the balanced mic/line Inputs to the mixer. For unbalanced connection, wire high (+) and ground to both ( ) & (-). Unbalanced 'pre-fader' Direct Outputs are available on Channels 1~8, using the (d. Master DIP Switches: These switches assign functions to the mixer as a whole (when pushed up). Aux Post assigns post-gate/level channel signals to the Aux Output (instead of pre-gate/level signals). DIP Switches (Channels 1~8): These switches assign functions to the individual channels (when pushed up). Duck Ch 8 (Channels 1~7 only) assigns channel signal to activate -12dB attenuation on Channel 8 (ducking). Aux Off (Channel 8 only) removes Channel 8 signal from Aux Output (mix-minus). [. . . ] statements, representations or warranties made by any dealer do not constitute warranties by Biamp Systems. Biamp Systems shall not be responsible or liable for any statement, representation or warranty made by any dealer or other person. No action for breach of this warranty may be commenced more than one year after the expiration of this warranty. BIAMP SYSTEMS SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING LOST PROFITS OR LOSS OF USE ARISING OUT OF THE PURCHASE, SALE, OR USE OF THE PRODUCTS, EVEN IF BIAMP SYSTEMS WAS ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Biamp Systems 9300 S. W. [. . . ]