User manual BIAMP ADVANTAGE SPM 522D

[. . . ] In order for the power supply capacitors to discharge, allow the amplifier power to remain off for at least five minutes before proceeding. · Remove the VA-8600 top cover (6 x #4x¼" self-tapping screws, 3 at front, 3 at rear). · Viewing the rear of the VA-8600, locate module position 10 as seen in the drawing below. [. . . ] · Viewing the rear of the VA-8600, locate module position 10 as seen in the drawing below. Remove the blank panel from this position (remove 3 x #4x¼" self-tapping screws, slide panel upwards). · Viewing the amplifier from the top, on the motherboard locate and remove the #4-32 machine screw marked 10 (near connector J10, AUX PWR). · Fit the PARM-1 module (with ribbon cable attached) by sliding the rear panel into the position formerly occupied by the blank panel. · Re-fit the three rear panel screws and re-fit the motherboard screw through the PARM-1 mounting bracket (marked MH3 on PARM-1 PCB). · Locate the NM-1 network module adjacent to the newly fitted PARM-1 module and on the NM-1, locate connector J17 `BACK PANEL'. · Plug the free end of the ribbon cable from the PARM-1 module into J17 of the NM-1 module, ensuring that pins are aligned and that the polarizing stripe on the cable is towards the top of the VA-8600 at both the NM-1 end of the cable and the PARM-1 end of the cable. · Check that all screws are tight and re-fit the VA-8600 top cover. Each PARM-1 module must be enabled in the Vocia software, under the VA-8600 Advanced Settings dialog window (under Options, check box `PARM-1 Module Installed'). As a condition to receiving the benefits of this warranty, you must provide BIAMP Systems with documentation that establishes that you were the original purchaser of the products. Such evidence may consist of your sales receipt from an authorized BIAMP Systems dealer. Transportation and insurance charges to and from the BIAMP Systems factory for warranty service shall be your responsibility. This warranty will be VOID if the serial number has been removed or defaced; or if the product has been altered, subjected to damage, abuse or rental usage, repaired by any person not authorized by BIAMP Systems to make repairs; or installed in any manner that does not comply with BIAMP Systems' recommendations. Electro-mechanical fans, electrolytic capacitors, gooseneck microphones, cords connecting handheld microphones, hard-drives, displays, and normal wear and tear of items such as paint, knobs, handles, keypads and covers are not covered under this warranty. This warranty is in lieu of all other warranties, expressed or implied. BIAMP Systems disclaims all other warranties, expressed or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. [. . . ] This warranty is in lieu of all other warranties, expressed or implied. BIAMP Systems disclaims all other warranties, expressed or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. [. . . ]