User manual BFT MOOVI 50

[. . . ] Make sure the stated temperature range is compatible with the site in which the automated system is due to be installed. The units making up the machine and its installation must meet the requirements of the following European Directives: 2004/108/EEC, 2006/95/EEC, 98/37/EEC, 99/05/EEC (and later amendments). For all countries outside the EEC, it is advisable to comply with the above-mentioned standards, in addition to any national standards in force, to achieve a good level of safety. The Company declines all responsibility for any consequences resulting from failure to observe Good Technical Practice when constructing closing structures (door, gates etc. [. . . ] When the operator is out of order, activate the emergency release (see Fig. Y), if necessary, so as to release the manual boom opening and closing operations. SCRAPPING Materials must be disposed of in conformity with the current regulations. In case of scrapping, the automation devices do not entail any particular risks or danger. In case of recovered materials, these should be sorted out by type (electrical components, copper, aluminium, plastic etc. DISMANTLING WARNING: before opening the door, the spring must be unloaded (vertical boom). When the automation system is disassembled to be reassembled on another site, proceed as follows: - Disconnect the power supply and the entire electrical installation. - In the case where some of the components cannot be removed or are damaged, they must be replaced. Correct controller operation is only ensured when the data contained in the present manual are observed. The Company is not to be held responsible for any damage resulting from failure to observe the installation standards and the instructions contained in the present manual. The descriptions and illustrations contained in the present manual are not binding. The Company reserves the right to make any alterations deemed appropriate for the technical, manufacturing and commercial improvement of the product, while leaving the essential product features unchanged, at any time and without undertaking to update the present publication. 2) GENERAL INFORMATION Compact electromechanical barrier suitable for enclosing private areas and car parks and for use across entrances used by vehicle traffic only. Adjustable electromechanical limit switches ensure the boom stops in the correct position. The emergency release for manual operation is operated by a lock with a personalized key. Where necessary, the opening direction can always be reversed with a few simple operations. CBO (on request) can be supplied to make the barrier easier to install. Provision for accessories makes installing them straightforward, with no need to drill additional holes. During the closing operation, the balancing spring must never be fully compressed. 3 shows the position for determining the minimum size that the compressed spring can be allowed to reach with the boom in the open position (vertical). E) - Foundation base CBO - Shearing hazard protection kit KIT MOOVI PRM - Photocell 130 fastening post kit KIT MOOVI 130 - Fixed end rest for boom FAF - Folding leg to support boom MOOVI GA (MOOVI 50 only) - Cushioned folding leg to support boom MOOVI GAMA - Skirt ready assembled on boom SB - Safety edge BIR - Lights kit for booms between 3m and 4. AF) For further information on installing and using the accessories, refer to the relevant instruction manual. [. . . ] If installed and used correctly, the automated system will meet the required level of safety. Nonetheless, it is advisable to observe certain rules of behaviour so that accidental problems can be avoided: - Keep adults, children and property out of range of the automated system, especially while it is operating. - This application is not meant for use by people (including children) with impaired mental, physical or sensory capacities, or people who do not have suitable knowledge, unless they are supervised or have been instructed by people who are responsible for their safety. - Children must be supervised to ensure they do not play with the application. [. . . ]