User manual BEST STRIP VETRO HF BIANCO 90

[. . . ] - The Buzzer emits a "beep" each time that a command is set from the keyboard or remote control (optional). - In the event of interruption of power during the hood, if you restore the hood in the OFF state, then the engine must be reactivate manually. Use a duct with as few elbows as possible (maximum Avoid drastic changes in the duct cross-section. Do not connect the hood to smoke exhaust ducts for For the air vents comply with the provisions laid down by the competent authorities. [. . . ] When this function is active, the LED corresponding to the speed (L1-L4) blinks. Filter alarm display: After 30 hours of motor operation, the LEDs L1-L5 come on for 30'' each time the motor is turned off. After 120 hours of motor operation, the LEDs L1-L5 blink for 30'' each time the motor is turned off. To reset the alarm, press any one of the keys P1-P5 for 2" during alarm display. 27: A = Stand-by/OFF/Slider When the chimney cooker hood is on, pressing this button will open the slider up to 30 cm. A second press on of the button will lift the chimney cooker hood to 40 cm. If the chimney cooker hood has not received further commands, Stand-by mode will turn on, which will then automatically turn off after 5 minutes. In Stand-by mode, buttons A will light, and buttons B, C, and F will only be backlit. When the chimney cooker hood is turned on, holding on the pressed button (> 2") will turn off the device (engine, lights, and timer, if it is turned on). Pressing the button while the truck is in motion, the direction is reversed. Cleanup Mode: Before cleaning the chimney cooker hood, make sure that the chimney cooker hood is turned off (only button A should be backlit). Pressing and holding the button (> 2") will turn on/off working mode for 3 minutes: during this time the chimney cooker hood must not receive any commands (all buttons are only backlit). In order to select high, medium, or low lighting level, or turn the lighting off completely, the button should be pressed several times. Holding on the pressed button (> 2") will turn on/off accessary lighting (only available in certain models). When the engine is not working, pressing the button will turn on the first speed mode of the When the engine is working, pressing this button will turn off the engine. D = Lower engine speed button E = Increase engine speed button L = Slider area for engine speed. In order to turn the Timer on, an appropriate button should be pressed. Engine will stop automatically after 5 minutes (button blinks rapidly). Pressing the button when the 5-minute Timer is on will turn on the 10-minute Timer (button blinks slowly). In order to turn the Timer off, press and hold the button (> 2"). After 30 hours of chimney cooker hood work, the necessity to clean antigrease filters will be signaled by backliting this button. In order to reset work time, press and hold the button (> 2"). [. . . ] If something appears not to be working properly, do the following simple checks before calling Technical Service: ?If the hood is not working: Check that: - The power has not been disconnected. If the hood performs inefficiently: Check that: - The motor speed selected is sufficient for the amount of smoke and vapours released. If the hood has turned off during normal functioning: Check that: - The power has not been disconnected. [. . . ]