User manual BESELER 23C ENLARGER

[. . . ] If this equipment does cause interference to radio or television reception (which can be determined by turning the equipment on and off), the user is encouraged to attempt to correct the interference by following the following steps: Reorient the antenna of the radio or television Relocate the computer with respect to the radio or television receiver Plug the computer into a different power outlet so that the computer and receiver are on different electrical branch circuits. If necessary, the user should consult with the dealer or an experienced radio/television technician for additional help and suggestions. The user may find the following booklet, prepared by the FCC, helpful in solving radio/television interference problems: "How to Identify and Resolve Radio-TV Interference Problems" This booklet is available by sending a written request to: U. S. Government Printing Office Washington D. C. , 20402 Request Stock Number 004-000-0345-4. ECC Statement This device complies with the requirements of EEC directive 89/336/EEC with regard to Electromagnetic Compatibility. [. . . ] If this product was acquired outside the United States or its Territories, then local law may apply. If you live in Canada, any other nations in Central & South America, including the Falkland Islands, or the United States, its Territories, and its Commonwealths, and you have questions regarding this EULA, please contact BESELER at this address: BESELER, Inc. 51 Discovery, Suite 100 Irvine, CA 92618, USA. If you live in any nation that is not located in the areas as listed above, please contact BESELER Int'l. 5-1 Innovation Road I/Science-Based Industrial Park/Hsin-Chu 300/Taiwan, R. O. C. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL BESELER OR ITS SUPPLIERS BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, DAMAGE TO COMPUTER SOFTWARE OR HARDWARE, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF THE USE OF, INABILITY TO USE THE SOFTWARE PRODUCT OR THE PROVISION OF, FAILURE TO PROVIDE SUPPORT SERVICES, OR INABILITY TO INSTALL THE HARDWARE PRODUCT, EVEN IF BESELER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU. 4 . . @n IP Company Contents Checklist 1. PenCam 2. Application / Driver CD Driver & Application 3. Install Quick Guide 4. USB Cable NOTE: If you are missing any of these contents please inform your dealer or your nearest support office so that the contents can be replaced. . . 5 . . Ins ta ic Qu l uid kG e System Requirements Microsoft Windows XP/ 98 / ME / 2000 Pentinum 200 MHz (or equivalent) processor or higher 32 MB of RAM (64 MB recommended) Video card with 2 MB of RAM for minimum 16 bit (High Color) display 4X speed CD-ROM An available USB port Specifications Sensor type: Color VGA(640x480)CMOS image sensor Iamge Performance for Video Stream: 9 fps for QVGA(320x240 Pixels) 3 fps for VGA(640x480 Pixels) Memory & Images (SDRAM 64Mbit): 26 Picture for VGA(640x480 Pixels), 107Pictures for QVGA(320x240 Pixels) Dimension:5. 6 " x1. 35 "x1 " Battery: AAA1. 5V x2 battery Lens view angle: 54 Degrees Interface type: USB Port Software Support: Microsoft Windows XP/ 98/ME/2000 Operating Environment The camera should be operated only within the following environmental conditions: 41-104 Fahrenheit; 5-40 Celsius 20% - 85% relative humidity, non-condensing PenCam Cautions!Never immerse any part of the PenCam or its components into any fluid or liquid. Remove dust or stains with a soft cloth dampened with water or neutral detergent. Do not use any volatile chemicals or liquids such as thinner or benzene to clean the PenCam. = Press "Snap Shot" button to capture an image to album folder. = Press "Record button" to recording a video clip to album folder. . . 13 . . DSC Mode Uploading Photos: This allows you to upload photos captured by the camera. < Press the "Link" button to link up the camera and upload photo icons. = Press the "Folder" button to open the album folder window. > Press the "Transfer all" or "Transfer selected" button to transfer photos to the album folder. = link up camera for image upload = Open or Close album folder window = Transfer selected photos to album folder = Transfer all photos to album folder . . 14 . . @n IP Company Editing Photos: It is easy to edit any photo you want in the album folder. Double click the photo icon to execute your default image application (such as Imaging, Paint. . . . etc. ) to edit your image file. Uploading Video: This takes advantage of the continuous mode. It is recommended that this be displayed in QVGA(low resolution mode). When the camera is full(107 pictures in continuous mode)attach it to the PC via the USB connector and run the AVI creator. Press the AVI Creator button, and your Images will be uploaded from the camera then processed into a video clip. [. . . ] Any attempt by the end user to disassemble any part of the HARDWARE PRODUCT, decompile any part of the software included with the HARDWARE PRODUCT, or damage any piece of the HARDWARE PRODUCT (including but not limited to accidental damage, incidental damage, purposeful damage, or damage caused by a person other than the End-User), shall immediately and irrevocably void the Limited Warranty. BESELER shall then be released from honoring any and all parts of this Limited Warranty, and the End-User will be ineligible for both the Warranty Service, and will also be ineligible for receiving Technical Support. The Limited Warranty cannot be transferred to another individual from the original purchaser, except as provided in the END-USER LICENSE AGREEMENT. If the HARDWARE PRODUCT is sold to another user by the original End-User, the Limited Warranty will be null and void, and BESELER will have no obligation to provide the Warranty Service. [. . . ]