User manual BERTAZZONI X244GGVX

[. . . ] Installation, Service and User Instructions FREESTANDING GAS RANGES BERTAZZONI DIMENSIONS: 24'' (605 mm)(W) x 25 1/8'' (640 mm)(D) x36'' (911 mm)(H) MODEL X244GGVX [MLS0GTU4X(2 or 5)A] 310287 IMPORTANT - PLEASE READ AND FOLLOW -Before beginning installation, please read these instructions completely and carefully. -Do not remove permanently affixed labels, warnings, or plates from the product. -The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. Installation must conform with local codes or in the absence of codes, the National Fuel Gas Code NSIZ223. 1-latest edition. [. . . ] Any other downward facing combustible surface less than 600mm above the top of the highest burner shall be protected for the full width and depth of the cooking surface area. However, in no case shall this clearance to any surface be less than 173/4"(450mm. ) Maximum depth for the overheads cabinet is 13" (330mm) 3 2. Side clearances (Minimum values) The different side clearances shall be in accordance with the minimum values indicated in the table n. 1 and are shown and in the fig. 1 The cooking surface area is defined as that part of the appliance where cooking normally takes place and does not include those parts of the appliance containing control knobs. Clearances inches (mm) L1 L2 L3 L4 L5 L6 L7 L8 L9 18 7/8" (480) 1 9/16" (40) 3 3/8" (86) 18" (457) 24" (610) 13" (330) 23 1/4" (590) 3/4" L10 L11 W D B1 (*) B2 (*) B3 (*) B4 (*) R 22 1/2" (570) 32" (813) 23 1/4" (590) 19 2/3" (500) 1 3/8" (35) 3 1/2" (90) 3" (76) 3 1/2" (90) 5 1/8"(135) (20) 3 15/16" (100) (*) Note: -B1 is the min. clearance between the front edge of the appliance and the front edge of the cabinet. clearance between the left/right side edge of the appliance and the side wall (if present). clearance between the back edge of the appliance and the back wall. Attaching the hotplate To prevent liquids from leaking accidentally into the underlying storage space, the appliance is equipped with a special gasket. Lay out the protective sealing strips along the edges of the opening in the bench top and carefully overlap the strip end. With a screwdriver assemble the brackets A to the hotplate bottom by means of the screws B. Trim the part of the sealing strips which extend beyond the hotplate base fig. 3 Gas connection fig. 4 Before connecting the appliance to the gas supply, first remove the plastic plug on which is pressfitted into the gas inlet union; to remove, just pull it off. Details of the injector sizes used are recorded on the data plate located on the base of the appliance. This appliance shall be installed in accordance with installation requirements of the local gas authority of the appropriate installation code. Before installing the hotplate consider the location of the gas supply and routing the gas line. (Refer fig. 5B) 4 4. For LPG models the gas supply is connected to the regulator which is supplied loose. IT IS ESSENTIAL THAT THE ELBOW ON THE APPLIANCE BE HELD FIRMLY WITH A SPANNER WHEN CONNECTING THE SUPPLY. For NG models the gas supply is connected to the regulator which is supplied loose. IT IS ESSENTIAL THAT THE ELBOW ON THE APPLIANCE BE HELD FIRMLY WITH A SPANNER WHEN CONNECTING THE SUPPLY. After installing the gas supply and making all connections check thoroughly for possible leaks. Using a soap and water solution check each gas connection one at the time, by brushing the solution over the connection. It is essential that the gasket and the pressure test point stopper are properly installed to avoid gas leakage Fig. 5B A B C D Fig. 5A Inches 1 9/16" 8 ¼" 8 ½" 1/8" mm 45 210 215 22 7. To checking inlet pressure at the appliance operate as follow: a) Disconnect electric power before pressure checking be carried out. b) Take off one of the gas burner cap and the relative flame spreader in order to get access to the burner injector. [. . . ] - Utilisez les pots avec un fond plat et épais, à l'exception de la cuisson avec poêles chinoises. - Quand vous utilisez les brûleurs, assurez-vous d'avoir positionné correctement les manches des casseroles. - Quand vous cuisinez des mets avec de l'huile ou de la graisse, qui sont très inflammables, l'utilisateur ne devra pas laisser l'appareil sans surveillance. 21 ATTENTION: Si l'alimentation est découpée, les brûleurs peuvent être allumés avec des allumettes. [. . . ]